M.A. Ford
M.A. Ford 16509370 Tuffcut GP 4 Flute Ball Nose End Mill Stub 3/32 pneumatic accessory
A 4-flute ball-nose stub end mill for profiling and contouring in general-purpose milling
- M.A. Ford quality for reliable milling performance
- Four-flute design improves material removal efficiency
- Ball nose geometry enables smooth contour cutting
- Stub length increases rigidity during operation
- 3/32 inch diameter suits precise detail work
M.A. Ford Tuffcut GP 4 Flute Ball Nose End Mill
The M.A. Ford Tuffcut GP is a 4 flute ball nose end mill designed for general-purpose milling. Its stub length provides rigidity during profiling and contouring operations. The tool suits CNC operators and machinists who need reliable performance in a variety of materials.
Suited for general milling; not for deep cavities
This end mill suits workshops performing general profiling, slotting and contouring where a stub length offers stability. Buyers who need extended reach for deep cavities or long overhangs should look at longer-length tooling instead. The 4 flute design supports efficient material removal in standard applications.
California Proposition 65 chemical warning included
The product carries a California Proposition 65 warning stating it contains a chemical known to cause cancer and birth defects or other reproductive harm. This notice informs users to follow safe handling practices such as proper ventilation and personal protective equipment. No additional accessories or software are bundled with the tool.
Highlights
- M.A. Ford quality for reliable milling performance
- Four-flute design improves material removal efficiency
- Ball nose geometry enables smooth contour cutting
- Stub length increases rigidity during operation
- 3/32 inch diameter suits precise detail work
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter collet or chuck do I need to hold the 3/32 stub shank on my milling machine?
Use a 3/32 inch collet or an adjustable chuck that clamps the stub shank securely; the shank diameter matches the 3/32 cutter size.
Can the 4 flute ball nose geometry cut the same materials as my older 2 flute end mills?
The 4 flute design gives a finer finish and higher feed rates in steels and alloys, but chip clearance is tighter than 2 flute tools, so reduce depth of cut in sticky materials.
How do I verify the TuffCut GP 16509370 is running true after installation?
Rotate the tool by hand to check for wobble, then run a short test pass at low speed; a smooth, even cut with no chatter confirms true running.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
