M.A. Ford
M.A. Ford 16507810 Tuffcut Gp 4 Flute Ball Nose End Mill Stub 5/64 pneumatic accessory
Four-flute ball-nose end mill cuts contoured profiles in a stub-length 5/64 format
- 4-flute design improves chip evacuation for smoother milling
- Ball nose profile enables precise contouring and 3D profiling
- Stub length increases rigidity for reduced deflection
- 5/64 inch diameter suits detailed finishing work
- New condition ensures full factory performance and reliability
M.A. Ford Tuffcut End Mill
The M.A. Ford 16507810 Tuffcut Gp is a four-flute ball nose end mill with a stub length and 5/64 size. It belongs to the Power & Pneumatic Accessories range and is supplied new from the manufacturer. Machinists use it for contouring and finishing operations in a variety of materials. The tool is identified by the manufacturer part number 16507810.
Thermals noise and power draw
As a solid carbide rotary cutter, the end mill generates heat only through friction at the cutting interface during machining. It has no motor, fan or electrical circuit, so it produces no intrinsic noise and draws no power of its own. Thermal load and acoustic output depend entirely on the machine spindle, feed rates and coolant strategy chosen by the operator.
California Proposition 65 notice
The product carries a California Proposition 65 warning stating it contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. This regulatory label does not alter the tool’s geometry, coating or cutting performance. Users should follow standard shop safety practices such as wearing gloves and washing hands after handling.
Highlights
- 4-flute design improves chip evacuation for smoother milling
- Ball nose profile enables precise contouring and 3D profiling
- Stub length increases rigidity for reduced deflection
- 5/64 inch diameter suits detailed finishing work
- New condition ensures full factory performance and reliability
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 5/64 ball nose end mill and what step is often missed?
Clamp the stub shank fully into a matching collet or chuck, then verify run-out before cutting; the step often missed is tightening the holder evenly so the 4-flute carbide does not walk.
What maintenance or replacement will this end mill need later?
The carbide flutes dull with use; plan to resharpen or replace the tool once the ball nose radius wears beyond tolerance, and inspect for chipping after each job.
What limit appears first under sustained use of this cutter?
Heat buildup at the 5/64 diameter causes flute wear and possible coating loss before the shank or holder reaches its limit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
