M.A. Ford
M.A. Ford 16504680 Tuffcut GP 4 Flute Ball Nose End Mill Stub 3/64 pneumatic accessory
A 4-flute ball-nose end mill with a 3/64 stub for milling contoured surfaces
- 4-flute design improves chip evacuation and surface finish
- Ball nose geometry enables 3D contouring and profiling
- Stub length increases rigidity for reduced deflection
- M.A. Ford quality ensures reliable cutting performance
- California Prop 65 warning indicates regulated chemical content
M.A. Ford Tuffcut GP End Mill
The M.A. Ford 16504680 Tuffcut GP is a 4 flute ball nose end mill with a stub length and 3/64 diameter. It is designed for general-purpose milling in a range of materials using CNC machines or manual mills. Machinists and fabricators use it for contouring, slotting and pocketing operations where a ball profile is required. The tool suits workshops needing a reliable cutter for everyday metal removal tasks.
Thermals noise and power draw
As a solid carbide rotary cutter, the end mill generates heat through friction at the cutting interface rather than through electrical consumption. Thermal load depends entirely on spindle speed, feed rate, material hardness and coolant strategy employed by the machine operator. No electrical power draw or acoustic rating applies to the accessory itself; the machine spindle determines those characteristics. Proper speeds and feeds with adequate coolant manage temperature at the cutting zone effectively.
California Proposition 65 warnings
The product carries California Proposition 65 warnings for chemicals known to cause cancer and birth defects or other reproductive harm. These regulatory notices inform the user about substances present in the tool material or coatings. The warnings do not alter the cutting performance, geometry or dimensions of the end mill. Safe handling practices such as wearing gloves and avoiding dust inhalation address the listed concerns during use and resharpening.
Highlights
- 4-flute design improves chip evacuation and surface finish
- Ball nose geometry enables 3D contouring and profiling
- Stub length increases rigidity for reduced deflection
- M.A. Ford quality ensures reliable cutting performance
- California Prop 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 3/64-inch Tuffcut GP end mill in my collet without run-out?
Clean the shank and collet bore, insert the tool fully, and tighten the collet nut to the holder's rated torque; the stub length leaves little room for error so verify concentricity with a dial indicator before cutting.
When should I replace this four-flute ball-nose cutter?
Replace it when flank wear reaches the supplier's recommended limit, when the ball radius shows measurable flattening, or if chipping appears on any flute — continued use degrades finish and can break the tool.
What is the first limitation I will hit during a long profiling pass in hardened steel?
Heat buildup at the 3/64-inch ball radius is the first limit; the small diameter evacuates chips slowly, so temperatures rise quickly and accelerate wear unless feed and coolant are optimised.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
