M.A. Ford
M.A. Ford 1570AP Cyclone Xd 5X Coolant Fed Double Margin Drill 15.70mm
Coolant-fed double-margin drill cuts 15.70 mm holes five diameters deep
- Coolant-fed design delivers lubrication to the cutting zone
- Double-margin geometry improves hole straightness and finish
- 5× diameter reach enables deeper drilling in one pass
- 70 mm diameter suits precise hole-making tasks
- New condition ensures full factory performance from first use
15.70mm Cyclone Xd drill for production machining
The M.A. Ford 1570AP Cyclone Xd is a 15.70mm coolant-fed double-margin drill designed for five-times-diameter depth capability. It targets machine shops and production cells that require accurate deep holes in a single pass without pecking.
Internal coolant delivery manages heat
Coolant flows through the tool to the cutting zone, controlling temperature and flushing chips from deep holes. The double-margin design adds guiding surfaces that stabilise the drill, reducing vibration and helping maintain size and finish during extended cuts.
Double margins improve hole straightness
The second margin supports the drill body throughout the cut, limiting deflection and improving roundness. Coolant-fed operation requires a compatible machine spindle and filtration setup, so shops without through-spindle coolant cannot use this tool as intended.
Highlights
- Coolant-fed design delivers lubrication to the cutting zone
- Double-margin geometry improves hole straightness and finish
- 5× diameter reach enables deeper drilling in one pass
- 70 mm diameter suits precise hole-making tasks
- New condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 15.70mm Cyclone Xd drill in a coolant-fed holder without damaging the double margins?
Mount the shank fully into the holder so coolant flows through the internal channels, then tighten evenly; the step often missed is verifying coolant exits both margins before cutting.
What maintenance or replacement will the 15.70mm Cyclone Xd drill need after extended use?
Inspect the double margins and cutting edges for wear; replace the drill when margin width drops below tolerance or when coolant flow diminishes due to internal buildup.
What limit appears first on the 15.70mm Cyclone Xd drill during sustained high-feed drilling?
Margin wear and heat buildup at the 15.70mm diameter typically limit tool life before the shank or coolant channels fail.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
