M.A. Ford
M.A. Ford 156M0400N35A TuffCut DM 2 Flute Ball Nose End Mill 4.0mm
A 4.0 mm necked ball-nose end mill with two flutes for contoured milling
- TypeCutting Tools
- 2-flute ball nose for smooth contour finishing
- 0 mm cutting diameter suits precise profiling
- Necked shank extends reach in deep cavities
- TuffCut DM coating resists wear in abrasive alloys
- California Proposition 65 warnings disclose regulated substances
M.A. Ford 156M0400N35A End Mill 4.0mm
The M.A. Ford 156M0400N35A is a TuffCut DM series end mill with a 4.0 mm ball nose and necked design. It features two flutes for efficient chip evacuation during profiling and contouring operations. This cutting tool is supplied new and intended for precision machining tasks.
Suited for machinists needing a small-diameter
This tool suits machinists producing 3D contours or finishing complex profiles in a variety of materials. It is not for buyers who need a larger cutting diameter or a higher flute count for heavy roughing passes. The Proposition 65 notice also means it is not for users who require materials without listed chemical warnings.
4.0 mm ball nose diameter decides fit
The 4.0 mm ball nose diameter is the primary specification that determines whether this end mill matches the required radius for a specific job. Verify this dimension against the drawing or CAM program before purchasing to ensure the correct profile is achieved.
Highlights
- 2-flute ball nose for smooth contour finishing
- 0 mm cutting diameter suits precise profiling
- Necked shank extends reach in deep cavities
- TuffCut DM coating resists wear in abrasive alloys
- California Proposition 65 warnings disclose regulated substances
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How deep can the 35 mm neck reach before the shank contacts the workpiece?
The necked design provides 35 mm of reach, allowing the 4.0 mm ball nose to cut deep cavities without shank interference.
Does the solid-carbide cutter run hot enough to need coolant during long profiling passes?
Solid carbide handles heat well, but flood or mist coolant is recommended for extended profiling to control temperature and extend edge life.
What shank size must my tool holder accommodate for this 4.0 mm end mill?
The cutter uses a standard 4.0 mm shank, so a 4 mm collet, hydraulic holder or shrink-fit chuck is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
