M.A. Ford
M.A. Ford 156M0300N8A Tuffcut Dm 2 Flute Ball Nose End Mill Necked 3.0Mm statue
A 3.0 mm necked two-flute ball-nose end mill for contoured milling cuts
- TypeCutting Tools
- 0 mm necked design enables deep-reach milling
- Two-flute ball nose geometry produces smooth contoured finishes
- TuffCut DM coating extends tool life in abrasive materials
- M.A. Ford precision grinding ensures consistent cutting performance
- California Proposition 65 warning discloses regulated chemical content
M.A. Ford 156M0300N8A Garden Statue
This item is a garden statue supplied by M.A. Ford and listed under garden decor. It carries the manufacturer part number 156M0300N8A and is offered in new condition. The product is intended for outdoor decorative display.
Suits buyers wanting a decorative garden piece
Collectors or homeowners seeking a functional cutting tool should look elsewhere because this listing describes a garden statue. The specifications classify it as garden decor rather than a cutting implement.
Classified as garden decor not a cutting tool
The category path places the item in Home & Outdoors > Garden Center > Garden Decor & Statues. This classification determines the product's purpose and distinguishes it from similarly named cutting tools.
Highlights
- 0 mm necked design enables deep-reach milling
- Two-flute ball nose geometry produces smooth contoured finishes
- TuffCut DM coating extends tool life in abrasive materials
- M.A. Ford precision grinding ensures consistent cutting performance
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What milling machine collet or holder fits the 3.0 mm shank of this end mill?
Use a collet or holder sized for a 3.0 mm shank; the necked design requires sufficient clearance behind the flutes.
Can the 2 flute ball nose geometry cut the same materials as older high-speed steel cutters I already own?
The Tuffcut DM carbide substrate allows higher speeds in steels and alloys where HSS would wear quickly.
How do I verify the tool is cutting correctly after installation?
Check for smooth chip evacuation, consistent surface finish on the radius, and no chatter at the programmed feed rate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
