M.A. Ford
M.A. Ford 156M0180N12A Tuffcut Dm End Mill 1.8mm
A 1.8 mm two-flute ball-nose end mill with a necked shank for precision milling
- TypeCutting Tools
- Precision ball-nose profile for smooth 3-D contours
- 8 mm cutting diameter suits fine-detail machining
- Two-flute geometry clears chips efficiently in tight spaces
- Necked shank reaches deep cavities without interference
- New condition ensures full factory performance from first use
1.8 mm ball-nose end mill
The M.A. Ford 156M0180N12A is a 2-flute Tuffcut DM end mill with a 1.8 mm cutting diameter and necked relief. It is intended for machinists and shops performing contouring, profiling or finishing passes in a range of materials. The tool is supplied new and ships directly from the manufacturer.
Replaces worn or undersized ball-nose tools
This cutter replaces dull or smaller-diameter ball-nose mills when a 1.8 mm radius is required for tight corner radii or 3D surfacing. The jump is worth it when the necked reach allows access to deep features that a standard length tool cannot clear. It also suits jobs needing the specific Tuffcut DM geometry for improved chip evacuation.
Check shank compatibility and safety data
Verify that your tool holder accepts the shank diameter of this 1.8 mm end mill before ordering. Confirm the neck length provides the reach your workpiece demands. The product carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm, so review handling procedures and personal protective equipment requirements.
Highlights
- Precision ball-nose profile for smooth 3-D contours
- 8 mm cutting diameter suits fine-detail machining
- Two-flute geometry clears chips efficiently in tight spaces
- Necked shank reaches deep cavities without interference
- New condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter fits the 1.8 mm necked end mill?
The cutter has a 1.8 mm neck diameter; match it to a collet or holder that accepts that shank size.
How do you install the 2 flute ball nose cutter without damaging the neck?
Clamp on the shank only, keep the 1.8 mm neck clear of the holder, and tighten evenly to avoid run-out.
When should the Tuffcut DM end mill be replaced?
Replace it when the ball nose shows visible wear, chipping, or when cut quality drops on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
