M.A. Ford
M.A. Ford 156M0150N20A Tuffcut 2 Flute Ball Nose End Mill Necked 1.5 mm
A 1.5 mm necked ball-nose end mill with two flutes for precision milling
- TypeCutting Tools
- 2-flute ball nose for smooth contour milling
- 5 mm diameter for fine-detail work
- necked design reaches deep cavities without interference
- TuffCut construction resists wear in tough materials
- California Proposition 65 warning for regulated substances
Cutting Tool for Precision Machining
This M.A. Ford Tuffcut end mill is a solid-carbide cutting tool with a 1.5 mm ball nose and necked design. It suits CNC operators and machinists who need accurate 3-D contouring, profiling or finishing in a range of materials. The two-flute geometry supports efficient chip evacuation during light to medium cuts.
Necked Reach and Two-Flute Geometry
The necked shank extends reach into deep cavities without reducing tool rigidity. A 20° helix angle balances edge strength with smooth cutting action. Two flutes provide generous chip space, reducing the risk of re-cutting chips and helping maintain surface finish on contoured surfaces.
1.5 mm Diameter Capacity and Limits
At 1.5 mm diameter the tool handles fine detail work and tight internal radii comfortably. It runs out when material removal rates demand a larger core or when heavy roughing exceeds the two-flute chip capacity. The necked length gives extra depth access but does not replace a longer overall tool for very deep pockets.
Highlights
- 2-flute ball nose for smooth contour milling
- 5 mm diameter for fine-detail work
- necked design reaches deep cavities without interference
- TuffCut construction resists wear in tough materials
- California Proposition 65 warning for regulated substances
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How often should I inspect or replace the 1.5 mm ball-nose cutter during production runs?
Check the 1.5 mm ball-nose cutter regularly for flank wear or chipping; replace it when the edge radius grows or surface finish on the 20 mm necked reach degrades beyond tolerance.
What stops me running this 2-flute Tuffcut end mill continuously at high feed?
The 1.5 mm diameter and 20 mm necked reach limit chip evacuation and tool deflection; heat builds quickly in deep slots, so the first limit is usually thermal softening or vibration before the shank overheats.
How much heat and noise should I expect when this end mill runs all day in a CNC router?
A 1.5 mm 2-flute cutter at typical spindle speeds generates moderate high-pitched cutting noise and localised heat at the tip; use coolant or air blast to keep the 20 mm necked zone from overheating during long cycles.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
