M.A. Ford
M.A. Ford 156M0150N16A Tuffcut DM 2 Flute Ball Nose End Mill 1.5 mm
A 1.5 mm two-flute ball nose end mill with a necked design for contoured milling
- TypeCutting Tools
- Precision ball nose for smooth 3D contours
- Two-flute design clears chips efficiently
- Necked shank reaches deep cavities
- TuffCut DM coating resists wear
- 5 mm diameter suits fine detail
Tuffcut DM Ball Nose End Mill
The M.A. Ford 156M0150N16A is a 2 flute ball nose end mill with a 1.5 mm cutting diameter. It is designed for precision contouring and finishing operations in a variety of materials. The necked design provides extended reach for deep cavity work. This tool suits machinists and manufacturers requiring accurate 3D profiling capabilities.
Upgrading from general purpose tooling
This end mill replaces standard uncoated or general purpose cutters when tighter tolerances and better surface finishes are required. The Tuffcut DM geometry is optimised for higher performance in demanding applications. The jump is justified when production demands consistent results on complex contours. It addresses the need for longer tool life in abrasive or hardened materials.
Capacity and headroom in milling operations
The 1.5 mm diameter handles fine detail work and small radius profiling with precision. The 2 flute configuration offers efficient chip evacuation in softer materials and non-ferrous alloys. It runs out when heavy material removal rates or high feed roughing are the primary goals. Buyers needing larger diameters or higher flute counts for aggressive roughing should consider other tooling options.
Highlights
- Precision ball nose for smooth 3D contours
- Two-flute design clears chips efficiently
- Necked shank reaches deep cavities
- TuffCut DM coating resists wear
- 5 mm diameter suits fine detail
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter fits the 1.5 mm ball nose end mill?
The cutter has a 1.5 mm cutting diameter and a necked design; it requires a collet or holder that matches the shank diameter supplied with the tool.
How do you install the necked ball nose cutter without damaging the flutes?
Clamp the shank only, keep the necked section clear of the holder jaws, and tighten to the holder manufacturer’s torque value to avoid run-out.
When should the 2 flute ball nose cutter be replaced?
Replace it when the ball nose radius shows visible wear, chipping, or when surface finish degrades beyond tolerance during profiling or finishing passes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
