M.A. Ford
M.A. Ford 156M0140N16A Tuffcut 1.4mm 2 Flute Ball Nose End Mill Necked
A 1.4 mm two-flute ball nose end mill with a necked design for contoured milling
- TypeCutting Tools
- 4 mm diameter for precise small-feature milling
- Two-flute design gives efficient chip clearance
- Ball nose profile creates smooth contoured surfaces
- Necked shank provides extra reach in deep cavities
- TuffCut coating extends tool life in abrasive materials
Cutting Tool for Precision Milling
The M.A. Ford 156M0140N16A Tuffcut is a 1.4 mm diameter ball nose end mill with a necked design and two flutes. It is intended for machinists and engineers performing detailed contouring or finishing passes in a variety of materials where reach and tool clearance are required.
Sustained Load Behaviour
The two-flute geometry promotes efficient chip evacuation during extended cutting cycles, helping to maintain consistent surface finish and reduce heat buildup in the cutting zone. The necked profile supports deeper cavity work without shank interference, allowing the tool to sustain engagement in pocketing operations.
Installation and Common Issues
The tool mounts in any standard collet or holder sized for its shank, requiring only proper run-out checks before use. Problems typically arise from excessive feed rates or insufficient coolant, which can cause premature flute wear or breakage in the necked section. California Proposition 65 warnings apply regarding chemical exposure.
Highlights
- 4 mm diameter for precise small-feature milling
- Two-flute design gives efficient chip clearance
- Ball nose profile creates smooth contoured surfaces
- Necked shank provides extra reach in deep cavities
- TuffCut coating extends tool life in abrasive materials
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How much heat does the 1.4 mm Tuffcut end mill generate during extended cutting sessions?
The solid carbide construction dissipates heat efficiently, and the two-flute design allows chips to clear quickly so the tool runs cooler even during long milling passes.
What machine setup is needed to hold the 1.4 mm necked shank securely?
A standard ER collet or shrink-fit holder that matches the shank diameter will grip the necked section without run-out.
Will the 156M0140N16A work in an older manual milling machine with limited spindle speed?
Yes — the geometry is designed for a wide speed range, so it cuts cleanly at the lower RPMs typical of older knee mills.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
