M.A. Ford
M.A. Ford 156M0100N16A Tuffcut Dm 2 Flute Ball Nose End Mill Necked 1.0Mm statue
A 1.0 mm two-flute ball-nose end mill with a necked design for deep milling
- TypeCutting Tools
- Precision milling with 2-flute ball-nose geometry
- Neck relief enables deep cavity access
- 0 mm diameter suits fine-detail work
- TuffCut DM coating resists wear in abrasive materials
- New condition ensures full factory performance
Product Identity
This M.A. Ford Tuffcut end mill is a two-flute ball-nose cutter with a necked shank and a 1.0 mm cutting diameter. It is intended for machinists and tool rooms performing contouring or finishing operations in a variety of materials.
Critical Specification
The necked geometry provides extended reach for deep cavities while maintaining rigidity at the 1.0 mm diameter. Select this tool when the workpiece requires a small-radius ball profile and the clearance that a necked shank delivers.
Thermal And Power Profile
Cutting forces remain modest at this diameter so spindle loads and heat generation are low during normal finishing passes. Standard coolant or air blast is sufficient to manage temperatures and evacuate chips without excessive power draw.
Highlights
- Precision milling with 2-flute ball-nose geometry
- Neck relief enables deep cavity access
- 0 mm diameter suits fine-detail work
- TuffCut DM coating resists wear in abrasive materials
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What does the 1.0 mm diameter mean when the end mill is in a machine?
The 1.0 mm diameter sets the cut width and the smallest internal radius you can mill with this tool.
What interface or standard governs the necked shank and what does it limit in practice?
The necked shank follows standard end-mill shank dimensions, limiting the maximum reach before the holder contacts the workpiece.
What does the tool physically need to fit or mount in a holder?
It requires a collet or chuck that matches the shank diameter, typically a standard ER or Weldon holder for the given shank size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
