M.A. Ford
M.A. Ford 15639370A 10.0mm Ball Nose End Mill
A 10.0 mm ball nose end mill with two flutes for precision contour milling
- TypeCutting Tools
- Precision milling with 2-flute ball-nose geometry
- 0 mm diameter suits detailed contour work
- TuffCut DM coating resists wear in tough materials
- M.A. Ford quality trusted by machinists worldwide
- California Prop 65 chemical notice included
10.0 mm Ball Nose End Mill
The M.A. Ford 15639370A is a solid-carbide cutting tool with a 10.0 mm diameter and a two-flute ball nose geometry. It is manufactured under the TuffCut DM designation for general-purpose milling operations. The tool arrives in new condition and ships directly from the manufacturer.
CNC operators needing a 10 mm ball profile
Machinists programming 3D contouring, profiling or finishing passes in steel, stainless steel or cast iron will find the two-flute design suitable for chip evacuation in these materials. Buyers who require a different cutting diameter, a higher flute count for finer finish, or a corner-radius geometry for flat-bottom pockets should select an alternative tool.
Verify tool holder and machine capacity
Confirm that your collet, shrink-fit holder or hydraulic chuck accepts a 10.0 mm shank before ordering. Check that the machine spindle provides sufficient rigidity and run-out control for solid-carbide tooling at the intended speeds and feeds. Review the Proposition 65 notice regarding chemical exposure during handling or machining.
Highlights
- Precision milling with 2-flute ball-nose geometry
- 0 mm diameter suits detailed contour work
- TuffCut DM coating resists wear in tough materials
- M.A. Ford quality trusted by machinists worldwide
- California Prop 65 chemical notice included
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What type of milling machine or CNC router is needed to run a 10.0 mm shank end mill?
A milling machine or CNC router with a collet or chuck that accepts a 10.0 mm shank diameter is required to hold this tool securely.
Can this 2 flute ball nose cutter be used on the same materials as older high-speed steel end mills?
The Tuffcut DM carbide construction allows higher cutting speeds and feeds than HSS tools, so parameters must be adjusted for the specific workpiece material.
How can I verify the 15639370A is cutting correctly after installation?
Check for a smooth surface finish on the contoured profile, listen for consistent cutting sound without chatter, and inspect the ball nose radius for even wear after the first job.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
