M.A. Ford
M.A. Ford 15623621A 6.0 mm Ball Nose End Mill
A 6.0 mm two-flute ball nose end mill for contoured milling in a necked design
- TypeCutting Tools
- Precision 6.0 mm ball nose for smooth 3D contours
- Two-flute design clears chips efficiently in deep cuts
- Necked shank reaches cavities without tool interference
- TuffCut DM coating resists wear in tough materials
- California Prop 65 warning informs safe handling practices
M.A. Ford 6.0 mm Ball Nose End Mill
The M.A. Ford 15623621A is a Tuffcut DM two-flute ball nose end mill with a necked design and a 6.0 mm cutting diameter. It is intended for milling operations that require contoured profiles and finishing passes in a variety of workpiece materials.
Two-flute necked geometry for chip clearance
The two-flute configuration provides room for chip evacuation while the necked shank allows access to deeper cavities without interference from the tool holder. This combination suits CNC machining centres and rigid milling setups where reach and surface finish are priorities.
California Proposition 65 compliance notice included
The product ships with a warning that it contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. This notice informs users of regulatory obligations but does not alter the tool’s cutting performance or installation requirements.
Highlights
- Precision 6.0 mm ball nose for smooth 3D contours
- Two-flute design clears chips efficiently in deep cuts
- Necked shank reaches cavities without tool interference
- TuffCut DM coating resists wear in tough materials
- California Prop 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How quickly does the 6.0 mm ball nose end mill wear when cutting hardened steel for hours?
The carbide substrate and coating on the 15623621A resist abrasion, but sustained heavy cuts will eventually dull the 6.0 mm radius; rotate tools to maintain finish.
Does the necked 2 flute design run hot or loud during a full production shift?
The necked geometry improves chip evacuation, reducing heat build-up and vibration, so the cutter stays cooler and quieter during extended runs.
What tool holder or collet must I already have to mount this 6.0 mm shank end mill?
A standard 6.0 mm ER collet, shrink-fit holder or hydraulic chuck with a matching 6.0 mm bore will secure the shank without additional adapters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
