M.A. Ford
M.A. Ford 15612501A Tuffcut DM End Mill 1/8
The TuffCut DM 2-flute ball-nose end mill cuts hardened steel with a necked reach
- TypeCutting Tools
- Tuffcut DM coating extends tool life
- Two-flute ball-nose geometry gives smooth 3-D contours
- Necked shank provides clearance in deep pockets
- 1/8 inch diameter suits fine-detail milling
- California Proposition 65 warning included for safety compliance
1/8-inch Tuffcut DM end mill
The M.A. Ford 15612501A is a two-flute ball nose end mill with a necked design for extended reach. It is intended for precision contouring and finishing operations in a variety of materials. This new cutting tool suits machinists and fabricators who need reliable performance on detailed workpieces.
Upgrade from standard stub-length tools
The necked geometry replaces shorter cutters when deep cavities or tight clearances prevent a standard shank from reaching the feature. The jump is worth it when the workpiece depth exceeds the cutting length of a conventional end mill and tool deflection becomes a concern.
Sustained cutting in deep pockets
Under continuous engagement the necked shank reduces interference between the holder and the workpiece wall. This maintains stability during long passes where a non-necked tool would rub or bind. The design supports consistent material removal without the chatter induced by excessive overhang.
Not for high-volume roughing
Buyers who need rapid stock removal in open areas will find the two-flute ball nose geometry less efficient than multi-flute roughers. The tool is not suited for heavy slotting or applications demanding maximum chip evacuation rates.
Highlights
- Tuffcut DM coating extends tool life
- Two-flute ball-nose geometry gives smooth 3-D contours
- Necked shank provides clearance in deep pockets
- 1/8 inch diameter suits fine-detail milling
- California Proposition 65 warning included for safety compliance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter does the 15612501A end mill need to fit my collet?
The tool has a 1/8 inch shank, so the collet or holder must accept that exact diameter.
How do I install the necked ball-nose cutter without damaging the reduced neck?
Clamp on the shank only, keep the neck clear of the holder face, and tighten the collet to the manufacturer's torque spec.
When should I replace the cutter based on wear or Prop 65 handling?
Replace when the ball nose shows visible flank wear or chipping; always wear gloves and wash hands after handling because of the Proposition 65 chemicals.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
