M.A. Ford
M.A. Ford 15055120 14.0 mm ball nose end mill
14 mm two-flute ball nose end mill cuts smooth 3D contours in steel and aluminium
- 0 mm diameter suits wide-contour profiling
- Two-flute design clears chips efficiently in deep cuts
- Ball-nose geometry produces smooth 3-D surface finishes
- M.A. Ford TuffCut GP series built for general-purpose milling
- California Proposition 65 warning applies to this product
M.A. Ford 15055120 ball nose end mill
The M.A. Ford 15055120 is a 14.0 mm diameter ball nose end mill from the Tuffcut Gp range. It features a two-flute design suited for contouring and profiling operations in milling applications. The tool is supplied new and ships directly from the manufacturer.
Machinists needing a 14.0 mm ball profile
This cutter suits machinists who require a 14.0 mm ball nose geometry for 3D surfacing or radius work in a two-flute configuration. It is not intended for users who need a different cutting diameter, a higher flute count for finishing, or a corner radius instead of a full ball profile.
California Proposition 65 notice
The product carries a California Proposition 65 warning stating it contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. This regulatory notice informs safe handling practices but does not alter the tool’s cutting performance or dimensions.
Highlights
- 0 mm diameter suits wide-contour profiling
- Two-flute design clears chips efficiently in deep cuts
- Ball-nose geometry produces smooth 3-D surface finishes
- M.A. Ford TuffCut GP series built for general-purpose milling
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What collet or chuck size is required to hold the 14.0 mm shank of this end mill?
A 14.0 mm collet or chuck is required to secure the shank of this end mill in the machine spindle.
Can the 15055120 be used in a manual milling machine with lower spindle speeds?
Yes, the two-flute ball nose geometry is suitable for manual machines, though feed rates should be reduced to match the lower spindle speed capability.
How can I verify the 15055120 is cutting correctly after installation?
Check for a smooth surface finish on the workpiece and listen for consistent cutting sounds without excessive vibration or chatter during operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
