M.A. Ford
M.A. Ford 15007870 Tuffcut GP 2 Flute Ball Nose End Mill 2.0 mm pneumatic accessory
Two-flute ball-nose end mill with a 2.0 mm cutting diameter for contouring and finishing operations
- Precise 2.0 mm ball nose for smooth contouring
- Two-flute design clears chips efficiently in tight slots
- M.A. Ford TuffCut GP geometry resists wear in steel
- New condition guarantees full factory performance
- California Prop 65 notice informs safe handling practices
What it is and who it is for
The M.A. Ford 15007870 Tuffcut GP is a 2.0 mm two-flute ball nose end mill designed for general-purpose milling in a range of materials. It suits machinists and fabricators who need a reliable carbide cutter for contouring, profiling and slotting operations on CNC or manual machines. Buyers requiring a larger diameter or a higher flute count for heavy roughing should look elsewhere.
Behaviour under sustained load
The two-flute geometry provides efficient chip evacuation during extended cuts, reducing the risk of clogging when machining deeper pockets or slots. Carbide construction maintains edge integrity at higher spindle speeds, allowing consistent material removal rates over long production runs without rapid dulling. The ball nose profile supports smooth 3D contouring passes across complex surfaces.
Thermals, noise and power draw
As a rotary cutting tool it generates heat at the cutting interface, so appropriate coolant or air blast is recommended to manage temperatures and prolong tool life. Noise levels depend on the machine spindle, workpiece clamping and cutting parameters rather than the cutter itself. Power consumption is determined by the machine drive and the chosen feed and speed settings.
Highlights
- Precise 2.0 mm ball nose for smooth contouring
- Two-flute design clears chips efficiently in tight slots
- M.A. Ford TuffCut GP geometry resists wear in steel
- New condition guarantees full factory performance
- California Prop 65 notice informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 2.0 mm shank run hot during continuous milling?
The solid-carbide 2.0 mm ball-nose cutter generates typical heat for its diameter; use flood coolant or mist to keep temperatures stable during long runs.
What holder is required to secure the 2.0 mm shank?
A collet chuck, shrink-fit holder or hydraulic chuck that accepts a 2.0 mm shank is needed; the tool has no integral shank flats or threads.
Will this 2.0 mm end mill work in a legacy manual mill with R8 spindle?
Yes, when paired with an R8-to-2.0 mm collet or drill chuck, the cutter fits and cuts normally in older manual machines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
