M.A. Ford
M.A. Ford 15007090 Tuffcut GP 2-flute ball nose end mill 1.8 mm pneumatic accessory
A 1.8 mm two-flute ball nose end mill for contour milling in pneumatic tools
- 2-flute ball nose for smooth contouring
- 8 mm diameter for fine detail work
- Tuffcut GP series built for general-purpose milling
- New condition ensures full tool life
- M.A. Ford quality for reliable performance
M.A. Ford Tuffcut GP ball nose end mill
The M.A. Ford 15007090 is a 1.8 mm two-flute ball nose end mill from the Tuffcut GP range. It is a power and pneumatic accessory built for milling operations that require a rounded cutting profile. Machinists and maintenance technicians use it for contouring, slotting and finishing in a variety of materials. The tool is supplied new and ships directly from the manufacturer.
California Proposition 65 chemical warnings
This product carries two California Proposition 65 warnings. One advises that the item contains a chemical known to the state to cause cancer. The other advises that it contains a chemical known to cause birth defects or other reproductive harm. These notices are regulatory disclosures and do not alter the tool's dimensions or cutting geometry. Buyers who must avoid listed substances should review the warnings before purchase.
1.8 mm cutting diameter decides fit
The single specification that determines whether this end mill suits the job is its 1.8 mm cutting diameter. That dimension fixes the minimum radius and the maximum step-over achievable in a single pass. If the design calls for a larger or smaller ball profile, this tool will not meet the requirement. No other size or shank variant is described in the data.
Highlights
- 2-flute ball nose for smooth contouring
- 8 mm diameter for fine detail work
- Tuffcut GP series built for general-purpose milling
- New condition ensures full tool life
- M.A. Ford quality for reliable performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
When will the 1.8 mm ball nose need replacing?
Replace the cutter when the ball radius wears enough to exceed your tolerance or when the flutes show visible rounding.
What limits continuous cutting with this 2-flute end mill?
Chip evacuation in deep slots is the first constraint; the two flutes pack quickly and raise cutting forces.
How much heat builds up during all-day milling?
The solid carbide body conducts heat into the shank, so the tool runs warm but stays within normal carbide operating temperatures.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
