M.A. Ford
M.A. Ford 15003000 Tuffcut Gp 2 Flute Ball Nose End Mill .0300 pneumatic accessory
Two-flute ball-nose end mill with .0300 diameter for precision contour milling
- Precision ball-nose profile for smooth 3D contours
- Two-flute design clears chips efficiently in tight slots
- TuffCut GP coating resists wear during extended runs
- .0300 inch diameter suits fine-detail machining tasks
- California Prop 65 warning informs safe handling practices
Tuffcut GP 2 Flute Ball Nose End Mill
The M.A. Ford 15003000 is a precision cutting tool designed for milling operations requiring a ball nose profile. It suits machinists and fabricators working with powered or pneumatic equipment who need a 2 flute geometry for specific material removal tasks. This accessory is supplied new and intended for professional workshop use.
Installation and common issues
The end mill installs directly into a compatible tool holder or collet on the power or pneumatic machine. Ensure the shank is fully seated and secured to prevent runout or tool slippage during operation. Common problems include premature wear or breakage if feed rates and speeds are not matched to the workpiece material and the small .0300 diameter.
Practical limits of the interface
Performance is constrained by the rigidity of the machine spindle and the holding capacity of the collet or chuck used. The small cutting diameter limits material removal rates and requires careful chip evacuation to avoid clogging in deep pockets. California Proposition 65 warnings indicate the presence of chemicals known to cause cancer and reproductive harm, requiring appropriate safety controls.
Highlights
- Precision ball-nose profile for smooth 3D contours
- Two-flute design clears chips efficiently in tight slots
- TuffCut GP coating resists wear during extended runs
- .0300 inch diameter suits fine-detail machining tasks
- California Prop 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How can I verify the 15003000 end mill is cutting correctly after installation?
Check that the two-flute ball nose produces a smooth radius finish without chatter or excessive vibration during operation.
What comes with the Tuffcut Gp end mill and what must I supply separately?
The package includes the 15003000 cutter only; you must provide a compatible tool holder, collet or chuck and the pneumatic or electric spindle to drive it.
Which version of the 15003000 should I choose for my application?
The 15003000 is a single .0300 diameter two-flute ball nose model; select it when that specific size and flute count match your milling requirements.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
