M.A. Ford
M.A. Ford 14098430T Tuffcut GP 4 Flute Ball Nose End Mill 25.0mm pneumatic accessory
Four-flute ball-nose end mill with 25.0 mm diameter for contour milling operations
- 4-flute design improves chip evacuation for smoother cuts
- 0 mm ball nose radius enables precise contouring
- Tuffcut GP coating extends tool life in tough materials
- M.A. Ford manufacturing ensures consistent quality and performance
- California Prop 65 warning informs safe handling practices
25.0 mm Ball Nose End Mill
The M.A. Ford Tuffcut GP 14098430T is a 25.0 mm diameter ball nose end mill with four flutes. It is designed for profiling, contouring and slotting operations in a range of materials. The tool suits CNC machinists and general engineering workshops needing a robust carbide cutter for 3D contour work.
Suited for contouring and profiling
This cutter suits operators producing complex 3D surfaces, mould cavities or radius details where a ball nose profile is required. It is not intended for high-feed roughing strategies that demand specialised chip-breaker geometries or for very small diameter detail work below the 25.0 mm size.
Check holder and machine capacity
Verify that your tool holder accepts a 25.0 mm shank and that the machine spindle provides sufficient rigidity and torque for a four-flute cutter of this diameter. Confirm the workpiece material and coolant arrangement match the cutter’s substrate before ordering. Note the Proposition 65 warning regarding chemical content.
Highlights
- 4-flute design improves chip evacuation for smoother cuts
- 0 mm ball nose radius enables precise contouring
- Tuffcut GP coating extends tool life in tough materials
- M.A. Ford manufacturing ensures consistent quality and performance
- California Prop 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size collet or tool holder do I need for the 25.0 mm shank on this end mill?
A 25.0 mm collet or a compatible tool holder with a matching bore is required to secure the shank in your milling machine spindle.
Can I run this 4-flute ball nose cutter on an older manual mill with limited rigidity?
The four-flute design increases chip load, so reduce the feed rate and take lighter radial cuts to avoid chatter on less rigid machines.
How do I verify the 14098430T is cutting correctly after installation?
Check for a smooth, continuous chip flow and a uniform surface finish on the workpiece; excessive vibration or rough finish indicates a setup issue.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
