M.A. Ford
M.A. Ford 14086620 Tuffcut GP 4 Flute Ball Nose End Mill 22.0mm pneumatic accessory
Four-flute ball-nose end mill with a 22.0 mm diameter for contour milling
- 4-flute ball nose design enables smooth contouring
- 0 mm diameter suits larger profiling tasks
- Tuffcut GP series built for general-purpose milling
- M.A. Ford quality ensures reliable cutting performance
- New condition guarantees full tool life from start
M.A. Ford Tuffcut GP End Mill
This M.A. Ford Tuffcut GP end mill is a 4 flute ball nose cutter with a 22.0 mm cutting diameter. It is manufactured for general-purpose milling in a range of materials. The tool suits machinists and maintenance teams needing a new ball nose profile for contouring and profiling work. It ships directly from the manufacturer as a new accessory.
California Proposition 65 Notice
This product contains a chemical known to the State of California to cause cancer. It also contains a chemical known to the State of California to cause birth defects or other reproductive harm. Users should follow standard workshop safety practices including dust extraction and personal protective equipment. The notice applies to the item as supplied new from the manufacturer.
4 Flute Ball Nose Geometry
The four flute design provides multiple cutting edges for material removal and surface finish. A ball nose tip allows smooth 3D contouring and radius generation in the workpiece. The shank and flute dimensions correspond to the 22.0 mm cutter diameter for standard toolholder compatibility. Buyers needing a different flute count or a corner radius profile should select an alternative tool.
Highlights
- 4-flute ball nose design enables smooth contouring
- 0 mm diameter suits larger profiling tasks
- Tuffcut GP series built for general-purpose milling
- M.A. Ford quality ensures reliable cutting performance
- New condition guarantees full tool life from start
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 22.0 mm shank in my tool holder, and what step is often missed?
Insert the shank fully into a clean collet or holder, then tighten evenly to the maker's torque spec; the step most often missed is verifying zero run-out before cutting.
What maintenance or replacement will the 4-flute ball nose need over time?
The cutting edges wear with use; plan to resharpen or replace the end mill once flank wear reaches the maker's limit or surface finish degrades.
What limit appears first on the 14086620 during prolonged heavy cuts?
Heat buildup at the ball nose typically limits sustained feed rates before tool deflection becomes critical.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
