M.A. Ford
M.A. Ford 14062500T Tuffcut GP 4 Flute Ball Nose End Mill 5/8 pneumatic accessory
A four-flute ball-nose end mill designed for milling contoured surfaces and 3-D profiling
- 4-flute ball nose cuts smooth contours in one pass
- Tuffcut GP coating resists wear for longer tool life
- 5/8 inch shank fits standard collets without adapters
- M.A. Ford brand trusted by machinists for consistent quality
- New condition delivers full factory performance from day one
5/8 inch four-flute ball nose
The M.A. Ford 14062500T Tuffcut GP end mill is a 5/8 inch diameter rotary cutter with four flutes and a ball nose profile. It is designed for contouring and profiling operations in general-purpose machining. Machinists and fabricators use it on CNC milling machines or manual mills equipped with suitable tool holders.
Replaces worn or smaller roughing tools
This cutter replaces a dull or undersized ball nose mill when finish quality or tool life drops below acceptable levels. The four-flute geometry increases feed rates over two-flute equivalents while maintaining chip evacuation in many materials. The jump is worth it when cycle time must shrink without sacrificing surface finish on contoured surfaces.
Handles medium-depth profiling passes
The tool comfortably handles medium-depth profiling passes in steel, cast iron and non-ferrous alloys where a ball nose profile is required. It runs out when extreme material removal rates demand specialised high-helix or coated roughers, or when very tight inside radii need a smaller diameter cutter. The 14062500 designation identifies this specific configuration in the Tuffcut GP range.
Highlights
- 4-flute ball nose cuts smooth contours in one pass
- Tuffcut GP coating resists wear for longer tool life
- 5/8 inch shank fits standard collets without adapters
- M.A. Ford brand trusted by machinists for consistent quality
- New condition delivers full factory performance from day one
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 14062500T end mill need to fit my collet?
The 5/8 inch ball nose end mill requires a matching 5/8 inch collet or tool holder for secure clamping.
How do I install the Tuffcut GP end mill without damaging the flutes?
Insert the shank fully into the collet, tighten evenly, and avoid side loading during the first plunge to protect the four cutting edges.
When should I replace the 14062500T ball nose cutter?
Replace the tool when the ball radius shows visible wear, chipping occurs on the flutes, or surface finish degrades on contoured parts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
