M.A. Ford
M.A. Ford 14050000T Tuffcut GP 4 Flute Ball Nose End Mill 1/2 in pneumatic accessory
Four-flute ball-nose end mill 14050000T cuts contoured profiles in 1/2 in milling operations
- 4-flute ball nose design enables smooth contour milling
- 1/2 inch diameter suits standard tool holders
- M.A. Ford manufacturing ensures consistent cutting performance
- TuffCut GP series built for general-purpose machining
- California Proposition 65 warning indicates regulated material content
M.A. Ford 14050000T End Mill
The M.A. Ford 14050000T Tuffcut GP is a 4-flute ball nose end mill designed for general-purpose milling operations. It suits machinists and maintenance professionals who need a reliable cutting tool for profiling and contouring tasks. The tool is supplied new and ships directly from the manufacturer. California Proposition 65 warnings apply regarding chemical content.
Machinists needing ball nose profiling
This cutter suits operators performing 3D contouring, pocketing or finishing passes where a ball nose geometry is required. It is not intended for buyers who need a square end mill for flat-bottom cavities or a roughing tool with chip-breaker geometry. Users requiring a different flute count, diameter or coating should select an alternative tool. The Proposition 65 notice indicates the presence of listed chemicals.
Standard tool holder installation
The end mill installs into a compatible tool holder or collet using standard clamping procedures for shank-type cutters. Ensure the holder is clean and the tool is secured to the correct projection length. Common issues include excessive runout from worn collets or insufficient clamping force, which can cause vibration and poor surface finish. Improper feed and speed settings may also lead to premature wear or tool breakage.
Highlights
- 4-flute ball nose design enables smooth contour milling
- 1/2 inch diameter suits standard tool holders
- M.A. Ford manufacturing ensures consistent cutting performance
- TuffCut GP series built for general-purpose machining
- California Proposition 65 warning indicates regulated material content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What milling machine or collet system accepts a 1/2 in shank end mill?
A milling machine or router with a 1/2 in collet or chuck is required to hold the 14050000T end mill securely during operation.
Can the 14050000T be used in the same setup as older high-speed steel ball nose cutters?
Yes, it fits the same 1/2 in tool holders, but the carbide Tuffcut GP design typically runs at higher speeds and feeds than older HSS cutters, so adjust parameters accordingly.
How do I verify the 14050000T is cutting correctly after installation?
Check for a smooth, chatter-free finish on the workpiece, consistent chip formation, and measure the finished radius to confirm the ball nose profile matches the programmed path.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
