M.A. Ford
M.A. Ford 14019680A Tuffcut GP 4 Flute Ball Nose End Mill 5.0 mm pneumatic accessory
Four-flute ball-nose end mill cuts 5.0 mm radii in general-purpose milling
- 4-flute ball nose cuts complex contours smoothly
- 0 mm diameter fits precise milling tasks
- Tuffcut GP design handles general-purpose machining
- M.A. Ford brand signals professional tool quality
- New condition ensures full cutting performance
Tool identity
The M.A. Ford 14019680A Tuffcut GP is a four-flute ball nose end mill with a 5.0 mm cutting diameter. It is manufactured for CNC milling operations that require contoured or radiused profiles in metal workpieces.
Upgrade scope
This cutter replaces worn or lower-flute ball nose tools when finish quality or tool life becomes insufficient. The step up is justified when a machinist needs the rigidity and chip evacuation of a four-flute design for profiling passes in steel or alloy.
Installation notes
The shank fits standard ER collets or end mill holders matching the tool diameter. Run-out should be checked after clamping because excessive eccentricity accelerates wear on the ball nose radius. Verify coolant delivery reaches the cutting zone to avoid built-up edge on stainless or titanium.
Highlights
- 4-flute ball nose cuts complex contours smoothly
- 0 mm diameter fits precise milling tasks
- Tuffcut GP design handles general-purpose machining
- M.A. Ford brand signals professional tool quality
- New condition ensures full cutting performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 5.0 mm Tuffcut GP end mill need in a collet or holder?
Use a 5.0 mm collet or shrink-fit holder that matches the shank; clean both surfaces before clamping to avoid runout.
How do you install the 4-flute ball nose cutter without damaging the flutes?
Insert the tool shank fully into the collet, tighten the nut to the holder’s rated torque, and never tap the flutes with a hammer.
When should the 14019680A ball nose end mill be replaced or resharpened?
Replace or send for regrind when the ball radius shows visible wear, cutting edges chip, or surface finish degrades on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
