M.A. Ford
M.A. Ford 14015620T Tuffcut GP 4 Flute Ball Nose End Mill 5/32 pneumatic accessory
Four-flute ball nose end mill cuts precise contours in milling applications
- 4-flute design for smooth contour milling
- Ball nose profile creates rounded internal corners
- TuffCut GP coating extends tool life in steel
- 5/32 inch diameter suits precision profiling tasks
- New condition ensures full cutting performance from first use
Tuffcut GP 4 Flute Ball Nose
The M.A. Ford Tuffcut GP 14015620T is a 4 flute ball nose end mill with a 5/32 diameter for general purpose milling. It suits machinists and maintenance teams cutting slots, profiles and contoured surfaces in steel, cast iron and non-ferrous alloys. The tool is supplied new and ships directly from the manufacturer. Orders of $75 or more qualify for free shipping.
Capacity and headroom
The four flute design gives good chip evacuation and finish quality on medium-depth cuts in a range of materials. It handles profiling and pocketing operations where a ball nose profile is required. The tool will reach its limit in very deep cavities or high-feed roughing where specialised geometries or coatings provide longer life. California Proposition 65 warnings apply for cancer and reproductive harm.
Upgrade path
This end mill replaces worn or lower-flute-count ball nose cutters in general purpose tooling sets. The jump is worth it when a shop needs consistent finish quality across mixed materials without changing to application-specific cutters. It is not suited for high-volume production runs that demand dedicated high-performance geometries or for extremely hard materials requiring specialised substrates.
Highlights
- 4-flute design for smooth contour milling
- Ball nose profile creates rounded internal corners
- TuffCut GP coating extends tool life in steel
- 5/32 inch diameter suits precision profiling tasks
- New condition ensures full cutting performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 5/32 ball nose end mill fit the collet on my older pneumatic die grinder?
The shank diameter matches standard 5/32 collets used on many pneumatic die grinders, so it should seat securely in your existing tool.
How can I confirm the 4-flute ball nose is cutting cleanly after installation?
Run the tool at the recommended speed and watch for smooth chip evacuation with no chatter marks on the workpiece surface.
Does the 14015620T come with any collets, lubricant or storage case, or must I buy them separately?
Only the end mill itself is included; collets, cutting fluid and a protective case are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
