M.A. Ford
M.A. Ford 14010000T Tuffcut GP 4 Flute Ball Nose End Mill pneumatic accessory
A four-flute ball-nose end mill for precision contour milling in CNC and pneumatic tooling setups
- M.A. Ford TuffCut GP end mill for precision contouring
- Four-flute design improves chip evacuation during milling
- Ball nose geometry creates smooth radius cuts
- New condition ensures full factory performance
- California Proposition 65 warning applies to this product
Application Scope
The M.A. Ford 14010000T Tuffcut GP is a four-flute ball nose end mill designed for general-purpose milling in workshops that use pneumatic tooling. It suits machinists and maintenance teams needing a reliable cutter for contouring and profiling tasks on a range of materials.
Build and Connection
The cutter carries the Tuffcut GP designation from M.A. Ford, indicating a construction intended for consistent performance in daily production environments. Its shank fits standard pneumatic holders, allowing quick changes without special adapters and keeping setup time short on the shop floor.
Upgrade Path
This end mill replaces worn or lower-flute ball nose cutters when finish quality and tool life become limiting factors. The step up is worthwhile for operators seeing premature wear or chatter on complex profiles, provided the machine rigidity and coolant setup match the tool’s demands.
Highlights
- M.A. Ford TuffCut GP end mill for precision contouring
- Four-flute design improves chip evacuation during milling
- Ball nose geometry creates smooth radius cuts
- New condition ensures full factory performance
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank standard does the 14010000T end mill use, and what collet size does that limit me to?
The 14010000T uses a standard shank that fits common ER or Weldon collets; the shank diameter determines the maximum collet bore you can clamp it in.
What machine spindle and holder clearance does the 14010000T ball-nose cutter require?
The four-flute ball-nose geometry needs a rigid milling spindle with enough axial clearance for the flute length and a holder that grips the full shank without overhang.
How do I install the 14010000T in a collet chuck, and what torque step do users often skip?
Insert the shank fully into a clean collet, tighten the nut to the holder manufacturer's specified torque, and verify run-out before cutting — many skip the torque check.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
