M.A. Ford
M.A. Ford 14007870A Tuffcut GP 4 Flute Ball Nose End Mill 2.0mm pneumatic accessory
Four-flute ball-nose end mill with a 2.0 mm cutting diameter for precision contour milling
- 4-flute ball nose cuts smooth contours
- 0 mm diameter fits fine detail work
- M.A. Ford quality ensures reliable performance
- TuffCut GP series built for general-purpose milling
- New condition guarantees full tool life
M.A. Ford 2.0 mm Ball Nose End Mill
The M.A. Ford 14007870A Tuffcut GP is a four-flute ball nose end mill with a 2.0 mm cutting diameter. It is designed for profiling, slotting and contouring operations in a range of ferrous and non-ferrous materials. The tool is supplied new and ships directly from the manufacturer. This accessory suits CNC operators and machinists who need a small-radius cutter for detailed work.
Machinists needing 2.0 mm radius profiling
This end mill suits CNC machinists and toolroom engineers who require a 2.0 mm ball nose for 3D contouring, finishing passes or tight-radius pockets. The four-flute geometry supports higher feed rates in suitable materials. It is not for buyers who need a larger cutting diameter, a different flute count or a corner-radius profile for flat-bottom features. Hand-held router users without rigid spindle control should also look elsewhere.
2.0 mm cutting diameter decides fit
The single specification that determines compatibility is the 2.0 mm cutting diameter. The tool holder, collet or spindle must accept this shank size and the machine must provide sufficient rigidity for a four-flute cutter at this scale. If the application demands a different diameter, flute count or end geometry, this part will not meet the requirement.
Highlights
- 4-flute ball nose cuts smooth contours
- 0 mm diameter fits fine detail work
- M.A. Ford quality ensures reliable performance
- TuffCut GP series built for general-purpose milling
- New condition guarantees full tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter fits the 2.0 mm M.A. Ford 14007870A Tuffcut GP end mill?
The cutter has a 2.0 mm shank, so it needs a 2.0 mm collet or a holder with a 2.0 mm bore.
How do I install the 2.0 mm M.A. Ford 14007870A Tuffcut GP end mill without excess run-out?
Clean the collet and shank, insert the tool fully, then tighten the collet nut evenly to the holder’s recommended torque.
When should I replace the 2.0 mm M.A. Ford 14007870A Tuffcut GP end mill?
Replace it when the ball-nose radius shows visible wear, chipping, or when surface finish degrades beyond tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
