M.A. Ford
M.A. Ford 14005910 Tuffcut GP 4 Flute Ball Nose End Mill 1.5mm pneumatic accessory
A 1.5 mm ball nose end mill with four flutes for contoured milling in pneumatic tools
- 4-flute ball-nose design enables smooth contour milling
- 5 mm diameter suits fine-detail machining
- TuffCut GP series built for general-purpose performance
- M.A. Ford quality ensures reliable cutting results
- New condition guarantees full tool life from first use
M.A. Ford Tuffcut GP End Mill
The M.A. Ford 14005910 Tuffcut GP is a 1.5 mm ball nose end mill with four flutes. It is made for machinists and fabricators who need precise contouring and finishing in a range of materials. This new cutting tool suits both CNC and manual milling operations where tight radius work is required.
Four-flute geometry for milling setups
The four-flute design increases feed rates and improves surface finish compared to two-flute alternatives. It fits standard collets and tool holders that accept a 1.5 mm shank, so no special adapters are needed. The geometry frees up machining time by allowing faster material removal on finishing passes.
1.5 mm diameter for fine detail work
The small diameter handles intricate profiles, tight corners and shallow pockets comfortably. It runs out when deep cavities or heavy roughing demand larger tools or longer reach. California Proposition 65 warnings apply: the product contains chemicals known to the state to cause cancer and birth defects or other reproductive harm.
Highlights
- 4-flute ball-nose design enables smooth contour milling
- 5 mm diameter suits fine-detail machining
- TuffCut GP series built for general-purpose performance
- M.A. Ford quality ensures reliable cutting results
- New condition guarantees full tool life from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
At what diameter does the 1.5 mm ball nose reach its limit under sustained use?
The 1.5 mm diameter is the critical dimension; sustained cutting loads concentrate stress at this size, making tool deflection the first limiting factor.
How much heat and noise does the 4 flute carbide end mill generate when running all day?
The solid carbide 4 flute design produces typical high speed milling heat and noise; flood or mist coolant manages temperature while the machine enclosure controls sound.
What tool holder and spindle interface must I already own to run the 14005910?
You need a precision collet or shrink fit holder that accepts a 3 mm or 1/8 inch shank and a spindle capable of the RPM range recommended for 1.5 mm ball nose milling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
