M.A. Ford
M.A. Ford 13625004 End Mill Finisher 1/4
A 1/4-inch two-flute end mill designed for finishing aluminium workpieces
- TypeCutting Tools
- Two-flute finisher leaves clean aluminium surfaces
- TuffCut Al geometry reduces built-up edge on soft alloys
- Quarter-inch shank fits standard collets and holders
- Brand-new tool arrives with full manufacturer edge integrity
- California Proposition 65 warning applies to this product
M.A. Ford 13625004 Tuffcut Al End Mill
This M.A. Ford 13625004 Tuffcut Al end mill is a two-flute cutting tool designed for finishing operations in aluminum. It serves machinists and fabricators who need a dedicated finisher for non-ferrous materials. The product is supplied new and carries California Proposition 65 warnings regarding cancer and reproductive harm.
Two-flute geometry for aluminum finishing
The two-flute design promotes efficient chip evacuation in soft, gummy aluminum alloys, reducing the risk of built-up edge during finishing passes. It fits standard tool holders matching its shank, freeing the operator from reconfiguring the spindle interface. Orders of $75 or more ship free directly from the manufacturer.
Upgrade from general-purpose roughers
This finisher replaces general-purpose end mills when surface quality and dimensional accuracy in aluminum become the priority. The jump is worth it when a final pass must leave a smooth finish without secondary hand work. It is not suited for heavy roughing, high-feed milling in steel, or operations requiring more than two flutes for chip management.
Highlights
- Two-flute finisher leaves clean aluminium surfaces
- TuffCut Al geometry reduces built-up edge on soft alloys
- Quarter-inch shank fits standard collets and holders
- Brand-new tool arrives with full manufacturer edge integrity
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What is the first performance limit reached during extended milling with the 13625004 end mill?
Tool wear on the two flutes becomes the primary limit as cutting edges dull under sustained load.
How much heat and noise does the 13625004 generate during all-day operation?
The cutter itself produces minimal noise; heat builds in the workpiece and spindle, so use coolant or air blast to manage temperatures.
What tool holder or collet is required to run the 13625004?
A 1/4 inch shank collet or end-mill holder matching your machine's spindle taper is needed to secure the cutter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
