M.A. Ford
M.A. Ford 13625000C Garden Statue
A 1/4 inch Tuffcut Al 2-flute end mill finisher for aluminium machining
- TypeCutting Tools
- 2-flute end mill designed for aluminium finishing
- 1/4 inch cutting diameter for precise milling
- TuffCut AL series optimised for non-ferrous metals
- California Proposition 65 warning for chemical exposure awareness
- Manufacturer direct shipping on orders of $75 or more
M.A. Ford 13625000C end mill
The M.A. Ford 13625000C is a two-flute Tuffcut Al end mill finisher with a 1/4 inch specification. It is designed for machining aluminium and similar non-ferrous materials where a fine surface finish is required. This cutting tool suits CNC operators and machinists who need reliable performance in finishing passes. The product is supplied new from the manufacturer.
Thermals noise and power draw
As a solid carbide rotary cutter, the tool generates heat only through friction at the cutting interface during normal milling operations. Noise levels depend entirely on the machine spindle, work-holding rigidity and the chosen feed and speed parameters. Power consumption is determined by the machine tool and the specific cutting strategy employed by the operator.
Sustained load behaviour
Under sustained cutting loads the carbide substrate maintains its geometry and edge integrity for consistent finishing results. Tool life in extended runs is governed by the selected cutting parameters, coolant use and the aluminium alloy being machined. The two-flute design aids chip evacuation during longer tool paths to reduce re-cutting risks. California Proposition 65 warnings apply to this product.
Highlights
- 2-flute end mill designed for aluminium finishing
- 1/4 inch cutting diameter for precise milling
- TuffCut AL series optimised for non-ferrous metals
- California Proposition 65 warning for chemical exposure awareness
- Manufacturer direct shipping on orders of $75 or more
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How do I install the 13625000C end mill in my machine, and what step is most often done wrong?
Insert the 1/4 inch shank fully into the collet or holder, then tighten the collet nut to the machine manufacturer's specified torque; the step most often missed is verifying the tool is seated completely before tightening.
What maintenance or replacement will the 13625000C need after extended cutting?
The cutting edges will gradually dull; plan to resharpen or replace the tool when finish quality drops or cutting forces rise noticeably.
What limit appears first on the 13625000C during a long production run?
Edge wear on the two flutes typically becomes the limiting factor before the carbide substrate or coating fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
