M.A. Ford
M.A. Ford 13598432 25.0 mm End Mill Statue
A 25.0 mm two-flute end mill for aluminium cutting, supplied new from M.A. Ford
- TypeCutting Tools
- M.A. Ford brand ensures professional cutting-tool quality
- 0 mm diameter suits large-scale milling tasks
- Tuffcut Al designation marks aluminium-optimised geometry
- Two-flute design promotes efficient chip evacuation
- California Prop 65 notice discloses regulated chemical content
25.0 mm End Mill Statue
This garden ornament replicates a M.A. Ford Tuffcut Al two-flute end mill at 25.0 mm scale. It is intended for outdoor display by machining enthusiasts or trade professionals who want a recognizable tool motif in their landscaping.
Sustained Outdoor Exposure
The statue is supplied new and constructed from materials that withstand continuous weather exposure without structural degradation. No protective coating maintenance is required for the item to remain intact through seasonal temperature cycles.
Build And Mounting Implications
A flat base allows stable placement on patios, gravel beds or lawn surfaces without additional anchoring hardware. The solid one-piece casting prevents water ingress and eliminates moving parts that could loosen over time. California Proposition 65 warnings apply because the material contains a listed chemical.
Highlights
- M.A. Ford brand ensures professional cutting-tool quality
- 0 mm diameter suits large-scale milling tasks
- Tuffcut Al designation marks aluminium-optimised geometry
- Two-flute design promotes efficient chip evacuation
- California Prop 65 notice discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the 25.0 mm end mill generate noticeable noise or heat during continuous milling?
The TuffCut AL 2-flute end mill runs quietly with minimal heat build-up in aluminium when proper feeds and speeds are used.
What machine and holder does the 25.0 mm shank require?
A milling machine with a 25.0 mm collet or end-mill holder and sufficient rigidity for two-flute aluminium cutting.
Will the 13598432 end mill work in an older manual knee mill?
Yes, it fits any machine that accepts a 25.0 mm shank, though older slides may limit feed rates for the two-flute geometry.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
