M.A. Ford
M.A. Ford 13598401N5 Garden Statue 25.0mm
TuffCut AL 2-flute necked end mill, 25.0 mm diameter for aluminium machining
- TypeCutting Tools
- 2-flute design enables efficient aluminium chip evacuation
- Necked profile provides extended reach for deep cavities
- 0 mm cutting diameter suits large-scale milling tasks
- TuffCut Al coating reduces built-up edge on non-ferrous metals
- California Proposition 65 warning informs safe handling practices
M.A. Ford 25.0mm End Mill
This M.A. Ford TuffCut AL end mill has a 25.0mm cutting diameter and a two-flute necked design. It is intended for machining aluminium and similar non-ferrous materials. The tool carries the manufacturer part number 13598401N5 and is supplied in new condition.
For aluminium milling, not general decor
Machinists and CNC operators cutting aluminium alloys will find this cutter suited to high-speed profiling and slotting. It is not a garden statue or decorative item despite the broad category listing. Buyers needing tools for steel, titanium or woodworking should select a different geometry.
Ships direct from manufacturer
The product ships directly from M.A. Ford and the supplier notes free shipping. California Proposition 65 warnings apply: the tool contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. No additional accessories or software are bundled with this cutting tool.
Highlights
- 2-flute design enables efficient aluminium chip evacuation
- Necked profile provides extended reach for deep cavities
- 0 mm cutting diameter suits large-scale milling tasks
- TuffCut Al coating reduces built-up edge on non-ferrous metals
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What milling machine or CNC spindle do I need to run this 25.0 mm end mill?
It requires a machine with a 25.0 mm tool holder or collet and enough rigidity for a two-flute necked carbide cutter.
Will this cutter fit in my existing tool changer that holds smaller shank tools?
Only if the changer accepts a 25.0 mm shank; smaller holders will not secure this end mill.
How can I confirm the tool is cutting correctly once installed?
Look for smooth chip evacuation, consistent finish on aluminium, and no chatter at the recommended feed and speed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
