M.A. Ford
M.A. Ford 13562904N5 End Mill 16.0mm
TuffCut AL two-flute necked end mill, 16.0 mm diameter for aluminium machining
- TypeCutting Tools
- 0 mm cutting diameter for precise aluminium milling
- Two-flute geometry clears chips efficiently in non-ferrous metals
- Necked shank provides extended reach in deep cavities
- TuffCut Al coating reduces built-up edge on aluminium alloys
- California Proposition 65 warning discloses regulated chemical content
16.0 mm Necked End Mill
M.A. Ford 13562904N5 is a two-flute necked end mill with a 16.0 mm cutting diameter. The TuffCut AL geometry is designed for aluminium and non-ferrous alloys. It is supplied new and ships directly from the manufacturer. California Proposition 65 warnings apply for cancer and reproductive harm.
Aluminium milling specialists
CNC programmers and machinists cutting aluminium, brass or copper alloys benefit from the necked reach and two-flute chip evacuation. Workshops that primarily machine hardened steel, titanium or high-silicon aluminium should select a different tool geometry. Buyers who need a coated or multi-flute cutter for abrasive materials will not be served by this model.
16.0 mm cutting diameter
The 16.0 mm diameter is the primary specification that determines whether this cutter fits the programmed tool path and holder. Verify the required diameter against your CAM setup before ordering. The necked profile provides additional reach for deep pockets. No other dimensions or coatings are detailed in the supplied data.
Highlights
- 0 mm cutting diameter for precise aluminium milling
- Two-flute geometry clears chips efficiently in non-ferrous metals
- Necked shank provides extended reach in deep cavities
- TuffCut Al coating reduces built-up edge on aluminium alloys
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How do I install the 16.0 mm necked end mill in my tool holder, and what step is often missed?
Clamp the shank at the necked section using a precision collet or hydraulic holder, then verify run-out before cutting; skipping the run-out check is the most common error.
What maintenance or replacement will the 2 flute TuffCut Al end mill need over time?
The cutting edges will dull with use; plan to re-sharpen or replace the tool once flank wear reaches the maximum allowance for your aluminium finish requirements.
What limit appears first during sustained high-speed aluminium milling with this 16.0 mm cutter?
Heat buildup in the flutes typically becomes the limiting factor before tool deflection, so use flood coolant or high-pressure air to maintain chip evacuation and tool life.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
