M.A. Ford
M.A. Ford 13562500N Tuffcut Al 2 Flute End Mill Necked 5/8 statue
A 5/8 inch necked two-flute end mill designed for aluminium cutting tasks
- TypeCutting Tools
- TuffCut Al coating extends tool life in aluminium
- Two-flute design clears chips efficiently for smooth finishes
- Necked shank provides extra reach in deep cavities
- 5/8 inch cutting diameter suits medium milling tasks
- California Proposition 65 warning included for safety compliance
Product Identity
The M.A. Ford 13562500N Tuffcut Al is a two-flute necked end mill intended for aluminium machining. It suits CNC operators and metalwork shops that need a dedicated tool for non-ferrous material removal.
Proposition 65 Notice
This product carries a California Proposition 65 warning for exposure to a chemical known to cause cancer. A second Proposition 65 warning covers a chemical known to cause birth defects or other reproductive harm. Buyers who require documentation free of these listed substances should look elsewhere.
Installation Notes
The shank fits standard 5/8 inch tool holders used on milling machines. Secure clamping prevents runout during high-speed aluminium cuts. The necked profile demands adequate clearance in deep pockets; insufficient reach is the common cause of interference.
Highlights
- TuffCut Al coating extends tool life in aluminium
- Two-flute design clears chips efficiently for smooth finishes
- Necked shank provides extra reach in deep cavities
- 5/8 inch cutting diameter suits medium milling tasks
- California Proposition 65 warning included for safety compliance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Should I choose the 13562500 model for aluminium milling?
The 13562500 TuffCut AL end mill is designed with two flutes and a necked profile for aluminium and non-ferrous materials.
What does the two-flute geometry mean when the tool is in the machine?
Two flutes provide large chip space for fast evacuation in soft alloys, reducing built-up edge and allowing higher feed rates.
What shank interface does the necked 5/8 end mill use?
The 5/8 diameter shank fits standard ER collets or Weldon holders, limiting run-out to the holder tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
