M.A. Ford
M.A. Ford 13547203N5 End Mill 12.0mm
Necked 12.0 mm end mill with two flutes designed for aluminium cutting
- TypeCutting Tools
- TuffCut Al coating extends tool life in aluminium
- Two-flute geometry clears chips efficiently for smooth cuts
- Necked design reaches deep cavities without deflection
- 0 mm diameter suits standard milling operations
- California Prop 65 notice discloses regulated chemicals present
12.0 mm Neck-End Mill for Aluminium
The M.A. Ford 13547203N5 is a two-flute necked end mill designed for aluminium machining. Its 12.0 mm cutting diameter suits CNC operators and job-shop technicians who need a dedicated aluminium tool. The necked profile provides extra reach for deeper cavities without shank interference. This cutter targets professionals producing non-ferrous components.
Upgrade from standard two-flute cutters
A conventional stub-length end mill limits reach in deep pockets and thin-wall parts. The necked geometry on this tool clears the shank past the cut depth, reducing deflection and chatter. The improvement matters when wall finish and dimensional tolerance are critical. Shops staying with short-flute tools will continue to hit reach constraints.
Practical limits of the necked design
The reduced shank section behind the flutes lowers overall rigidity compared with a solid-shank cutter of the same diameter. Excessive axial depth or aggressive feed rates can induce vibration in harder aluminium alloys. Operators must balance reach gains against the deflection penalty inherent to any necked tool. California Proposition 65 warnings apply to this product.
Highlights
- TuffCut Al coating extends tool life in aluminium
- Two-flute geometry clears chips efficiently for smooth cuts
- Necked design reaches deep cavities without deflection
- 0 mm diameter suits standard milling operations
- California Prop 65 notice discloses regulated chemicals present
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank size fits the 12.0 mm necked end mill?
The cutter has a 12.0 mm neck diameter, so the holder or collet must accept a 12.0 mm shank for proper fit.
How do you install the 2-flute Tuffcut Al end mill without damaging the neck?
Clamp on the shank only, never on the necked section, and tighten the collet evenly to avoid run-out on the 12.0 mm tool.
When should the 12.0 mm aluminium end mill be replaced?
Replace it when the cutting edges show visible wear, chipping, or when surface finish on aluminium deteriorates despite correct feeds.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
