M.A. Ford
M.A. Ford 13539371N 10.0 mm End Mill
A 10.0 mm necked two-flute end mill designed for aluminium cutting applications
- TypeCutting Tools
- 2-flute design for efficient aluminium chip evacuation
- Necked profile allows deeper cavity reach without interference
- 0 mm cutting diameter suited for medium milling passes
- TuffCut Al geometry reduces built-up edge on non-ferrous alloys
- California Proposition 65 notice included for chemical transparency
M.A. Ford 13539371N Tuffcut Al End Mill
The M.A. Ford 13539371N is a Tuffcut Al 2 flute end mill with a necked design and a 10.0 mm diameter. It is manufactured for machining aluminium and similar non-ferrous materials. The tool is supplied new and ships directly from the manufacturer. California Proposition 65 warnings apply to this product.
Suited for aluminium milling, not for ferrous metals
This end mill suits machinists and fabricators producing slots, pockets or profiles in aluminium alloys where the necked shank provides extra reach. It is not intended for steel, stainless steel, titanium or hardened materials where different geometries and coatings are required. Buyers needing higher flute counts, different helix angles or cutting diameters other than 10.0 mm should select another tool.
10.0 mm diameter necked 2 flute geometry
The decisive specification is the 10.0 mm cutting diameter combined with a necked 2 flute design optimised for aluminium. This geometry determines chip evacuation, reach and finish quality in the target material. Verify that your holder, machine rigidity and programmed parameters match this diameter and flute configuration before purchase.
Highlights
- 2-flute design for efficient aluminium chip evacuation
- Necked profile allows deeper cavity reach without interference
- 0 mm cutting diameter suited for medium milling passes
- TuffCut Al geometry reduces built-up edge on non-ferrous alloys
- California Proposition 65 notice included for chemical transparency
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the M.A. Ford 13539371N end mill come with any holders, collets or additional accessories?
The product is supplied as the 10.0 mm Tuffcut Al 2-flute necked end mill only. Tool holders, collets or other accessories must be purchased separately.
Should I choose the 10.0 mm diameter version or look for a different size?
Select the 10.0 mm diameter when your operation requires that exact cutting width; other diameters are separate part numbers and not interchangeable with this model.
What does the 10.0 mm diameter mean for actual machining performance?
The 10.0 mm cutting diameter sets the width of each pass and determines the maximum slot width the tool can produce in a single cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
