M.A. Ford
M.A. Ford 13539307N3 End Mill 10.0Mm 2 Flute Necked
TuffCut AL two-flute necked end mill, 10.0 mm diameter, designed for aluminium machining
- TypeCutting Tools
- 0 mm necked design clears deep cavities
- Two-flute geometry evacuates chips in aluminium
- TuffCut AL coating extends tool life
- Brand-new condition guarantees full factory performance
- California Proposition 65 chemical warning included
10.0 mm necked end mill for aluminium
The M.A. Ford 13539307N3 is a 10.0 mm diameter, two-flute cutter with a necked shank. It is designed for aluminium machining where chip evacuation and reach are priorities. The tool suits CNC operators and job-shop machinists who need a dedicated aluminium end mill.
Two-flute geometry maintains chip flow in deep slots
The two-flute design provides large gullets that move aluminium chips away from the cut during sustained profiling or slotting. Necked relief reduces wall contact, lowering deflection when the tool extends beyond standard flute length. This geometry supports consistent material removal without re-cutting chips in longer passes.
Carbide substrate resists wear in abrasive alloys
Solid carbide construction handles the heat generated by high-speed aluminium cutting while retaining edge sharpness. The uncoated surface prevents built-up edge common with sticky alloys. California Proposition 65 notices apply: the product contains a chemical known to the state to cause cancer and a chemical known to cause birth defects or other reproductive harm.
Highlights
- 0 mm necked design clears deep cavities
- Two-flute geometry evacuates chips in aluminium
- TuffCut AL coating extends tool life
- Brand-new condition guarantees full factory performance
- California Proposition 65 chemical warning included
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the 10.0 mm necked end mill generate noticeable vibration or heat during extended aluminium profiling?
The 2-flute geometry and necked design are intended for efficient chip evacuation in aluminium, reducing heat build-up during long passes.
What tool-holding system is required to run the 10.0 mm shank securely?
A precision collet chuck, shrink-fit holder or hydraulic chuck sized for a 10.0 mm shank provides the rigidity needed for the TuffCut AL series.
Can the 13539307N3 be used on a manual knee mill with standard R8 tooling?
The 10.0 mm shank requires a metric collet or adapter; it will not fit directly into imperial R8 collets without a suitable reducing sleeve.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
