M.A. Ford
M.A. Ford 13537501N Tuffcut Al 2 Flute End Mill Necked 3/8 statue
A 3/8-inch necked two-flute end mill for aluminium machining, supplied new by M.A. Ford
- TypeCutting Tools
- 2-flute design clears aluminium chips efficiently
- TuffCut Al coating extends tool life in non-ferrous metals
- Necked profile reaches deep cavities without deflection
- 3/8 inch shank fits standard collets and holders
- California Prop 65 warning discloses regulated chemical content
Cutting tool for aluminium
The M.A. Ford 13537501N Tuffcut Al is a two-flute end mill with a necked design and a 3/8 measurement. It is manufactured by M.A. Ford and listed under cutting tools for machining aluminium workpieces.
For machinists working in aluminium
This cutter suits operators who need a dedicated aluminium end mill with a necked profile for reach. It is not for buyers who want a tool optimised for steel, titanium or other ferrous materials, nor for those needing a higher flute count for finishing passes.
Behaviour during extended cutting
The two-flute geometry provides large chip space for aluminium evacuation during sustained engagement. The necked section allows deeper cavity access without shank interference, while the Prop 65 notice indicates the presence of listed chemicals requiring workplace handling awareness.
Highlights
- 2-flute design clears aluminium chips efficiently
- TuffCut Al coating extends tool life in non-ferrous metals
- Necked profile reaches deep cavities without deflection
- 3/8 inch shank fits standard collets and holders
- California Prop 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What milling machine or router is required to hold the 3/8 shank of this Tuffcut Al end mill?
A milling machine or router with a 3/8 collet or chuck is needed to secure the 13537501N Tuffcut Al end mill for operation.
Can this two-flute necked end mill run on an older manual mill with lower spindle speeds?
Yes, the 13537501N Tuffcut Al end mill can be used on older manual mills; reduce feed rates to match the lower spindle speeds available.
How can I confirm the Tuffcut Al end mill is cutting correctly after setup?
Verify clean chip formation, smooth surface finish on the aluminium workpiece, and absence of chatter or excessive tool wear during the cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
