M.A. Ford
M.A. Ford 13537500N Tuffcut Al End Mill 2 Flute Necked 3/8
A two-flute necked end mill designed for aluminium cutting, supplied new from M.A. Ford
- TypeCutting Tools
- Brand M.A. Ford ensures reliable cutting performance
- Tuffcut Al design optimised for aluminium machining
- Two-flute geometry allows efficient chip evacuation
- Necked profile provides extended reach in deep pockets
- California Proposition 65 warning informs safe handling practices
Product identity
The M.A. Ford 13537500N Tuffcut Al is a two-flute necked end mill built for aluminium machining. It serves CNC operators and job-shop technicians who need a dedicated tool for non-ferrous material removal.
Sustained-load behaviour
The necked geometry provides extra reach for deep pockets while the two-flute design promotes efficient chip evacuation during extended cuts. This reduces the likelihood of chip re-cutting and helps maintain consistent material-removal rates over long production runs.
Thermals noise and power
The uncoated carbide substrate runs cool in aluminium because the sharp edge geometry minimises friction and heat generation. Lower cutting temperatures reduce thermal expansion in the workpiece and keep spindle loads steady, which contributes to quieter operation and predictable power draw on the machine.
Highlights
- Brand M.A. Ford ensures reliable cutting performance
- Tuffcut Al design optimised for aluminium machining
- Two-flute geometry allows efficient chip evacuation
- Necked profile provides extended reach in deep pockets
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Will the 2-flute necked geometry run cooler during extended aluminium profiling?
The 2-flute necked design clears chips efficiently in aluminium, reducing heat build-up during long machining sessions.
Which tool-holder interface matches the 3/8 shank on this end mill?
A standard 3/8-inch collet or shrink-fit holder accepts the shank directly for secure clamping.
Can the 13537500N Tuffcut Al be used in older manual knee mills?
Yes, the 3/8 shank and 2-flute geometry work well on conventional knee mills for aluminium profiling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
