M.A. Ford
M.A. Ford 13531507N3 Tuffcut Al 2 Flute End Mill Necked 8.0Mm statue
Two-flute aluminium end mill with necked 8.0 mm shank for slotting and profiling
- TypeCutting Tools
- TuffCut AL coating boosts aluminium cutting performance
- Two-flute design clears chips efficiently in soft metals
- Necked profile reaches deep cavities without interference
- 0 mm diameter suits standard milling operations
- California Prop 65 warning flags regulated chemical content
Product Identity
This is an M.A. Ford Tuffcut Al two-flute necked end mill with an 8.0 mm cutting diameter. It is a precision cutting tool intended for aluminium and similar non-ferrous materials in milling operations.
Who It Suits
Machinists and CNC operators who need a necked two-flute geometry for aluminium work will find this tool appropriate. Buyers who require a different flute count, a different shank style, or a cutting diameter other than 8.0 mm should look at something else.
Deciding Specification
The 8.0 mm cutting diameter is the single specification that determines whether this end mill fits the programmed tool path and workpiece requirements. Verify this dimension against your CAM setup before ordering.
Highlights
- TuffCut AL coating boosts aluminium cutting performance
- Two-flute design clears chips efficiently in soft metals
- Necked profile reaches deep cavities without interference
- 0 mm diameter suits standard milling operations
- California Prop 65 warning flags regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How can I confirm the 8.0Mm Tuffcut Al end mill is cutting correctly after setup?
Check for smooth, chatter-free cuts in aluminium with consistent chip evacuation; the two-flute necked design should leave a clean finish without built-up edge when run at recommended speeds.
What comes with the 13531507N3 end mill and what must I supply?
The box contains the single 8.0Mm necked carbide end mill only; you must provide a compatible tool holder, coolant or mist system, and a machine spindle capable of the required RPM range.
Which Tuffcut Al version should I choose for slotting versus profiling in aluminium?
Select the 2-flute necked 8.0Mm geometry for deep profiling and pocketing where reach matters; a standard-length 2-flute or 3-flute variant would be better for shallow slotting where rigidity is higher.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
