M.A. Ford
M.A. Ford 13531501N5 8.0 mm End Mill
8.0 mm two-flute necked end mill for aluminium machining, branded M.A. Ford TuffCut
- TypeCutting Tools
- Tuffcut Al coating for aluminium cutting
- 2-flute design enables efficient chip evacuation
- Necked profile provides extended reach in deep cavities
- 0 mm cutting diameter suits precise milling tasks
- New condition ensures full factory performance
M.A. Ford 8.0 mm End Mill
The M.A. Ford 13531501N5 is a TuffCut AL two-flute end mill with a necked design and an 8.0 mm cutting diameter. It is manufactured for aluminium and non-ferrous milling in CNC machining centres and manual mills.
Necked two-flute geometry
The necked relief provides extended reach into deep pockets and cavities without shank interference. Two flutes create large chip gullets that evacuate aluminium chips efficiently and reduce the risk of re-cutting or built-up edge.
CNC aluminium milling workflow
The cutter fits standard ER collets or Weldon holders that accept an 8.0 mm shank. It frees up Z-axis travel by allowing deeper axial engagement in a single pass, which reduces cycle time on pocketing and profiling operations.
Highlights
- Tuffcut Al coating for aluminium cutting
- 2-flute design enables efficient chip evacuation
- Necked profile provides extended reach in deep cavities
- 0 mm cutting diameter suits precise milling tasks
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How does the 8.0 mm diameter perform when cutting aluminium in a milling machine?
The 8.0 mm TuffCut AL end mill uses two flutes and a necked design to evacuate chips efficiently in aluminium, reducing built-up edge and leaving a smooth finish at standard milling speeds.
What shank standard does the 13531501N5 end mill use for tool-holder compatibility?
The tool is manufactured to industry-standard shank tolerances for 8.0 mm cutting diameter, allowing direct clamping in ER collets, Weldon flats or hydraulic holders without adapters.
What clearance does the necked section provide for deep pocket milling?
The necked profile behind the 8.0 mm cutting flutes gives extra reach so the shank clears deep pocket walls, preventing interference during extended axial cuts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
