M.A. Ford
M.A. Ford 13523605N5 6.0 mm End Mill
Two-flute necked end mill in 6.0 mm aluminium alloy cuts deep slots cleanly
- TypeCutting Tools
- 0 mm diameter fits precise milling tasks
- Two-flute geometry clears chips in aluminium alloys
- Necked design reaches deep cavities without interference
- TuffCut Al coating resists wear in non-ferrous cutting
- California Proposition 65 warning lists cancer and reproductive-harm chemicals
M.A. Ford TuffCut AL End Mill
The M.A. Ford 13523605N5 is a 6.0 mm necked end mill with two flutes designed for aluminium machining. It suits CNC operators and hobbyists who need clean chip evacuation in non-ferrous materials.
Necked geometry for deeper reach
The necked shank provides clearance for deeper pockets without shank interference. Two flutes create wide chip space that reduces clogging during high-feed aluminium cuts, while the uncoated carbide substrate resists built-up edge on soft alloys.
Replaces standard stub-length tools
This cutter upgrades from short-reach end mills when wall depth exceeds flute length. The jump is worthwhile when a single pass must reach past the flute zone without changing tools, but it does not serve hardened steels or high-temperature alloys.
Highlights
- 0 mm diameter fits precise milling tasks
- Two-flute geometry clears chips in aluminium alloys
- Necked design reaches deep cavities without interference
- TuffCut Al coating resists wear in non-ferrous cutting
- California Proposition 65 warning lists cancer and reproductive-harm chemicals
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What does the California Proposition 65 warning on this M.A. Ford 13523605N5 end mill cover?
The warning states the product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
What shank diameter matches the 6.0 mm cutting size of this Tuffcut Al necked end mill?
A 6.0 mm shank is standard for a 6.0 mm cutting diameter, so the tool fits a 6.0 mm collet or holder directly.
How do you install this 2-flute necked end mill in a milling machine without damaging the necked section?
Clamp the shank only, keep the necked portion clear of the collet face, and tighten to the holder manufacturer's torque spec.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
