We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical end mill with two flutes and a necked shank, 6.0 mm diameter

M.A. Ford

M.A. Ford 13523604N5 End Mill 6.0 mm

SKU CH-2GXB-H9JR4

A 6.0 mm necked two-flute end mill designed for aluminium cutting applications

  • TypeCutting Tools
  • TuffCut AL coating optimises aluminium cutting
  • Two-flute geometry clears chips efficiently
  • Necked design reaches deep cavities
  • 0 mm diameter suits standard tooling
  • California Proposition 65 warning applies

Tool Identification

The M.A. Ford 13523604N5 is a Tuffcut Al 2-flute end mill with a 6.0 mm cutting diameter and a necked design. It is intended for machinists and fabricators who need a dedicated aluminium milling cutter. Buyers who require a different diameter, flute count or coating for other materials should look elsewhere.

Installation Notes

The cutter mounts in a standard ER collet or shrink-fit holder matched to its shank. Run-out must be checked after clamping because excessive eccentricity causes chatter and poor finish in aluminium. Using an incompatible holder or skipping the run-out check are the most common causes of premature wear.

Application Limits

The 2-flute geometry and uncoated carbide substrate are optimised for high chip evacuation in non-ferrous alloys. The tool is not suited for hardened steels, high-temperature alloys or abrasive composites where a coated or higher-flute-count cutter would be required. California Proposition 65 warnings apply because the product contains listed chemicals.

Highlights

  • TuffCut AL coating optimises aluminium cutting
  • Two-flute geometry clears chips efficiently
  • Necked design reaches deep cavities
  • 0 mm diameter suits standard tooling
  • California Proposition 65 warning applies

Specifications

BrandM.A. FORD
TypeCutting Tools

Questions about this item

How can I verify the 6.0 mm necked end mill is cutting correctly after setup?

Check for smooth chip evacuation, consistent surface finish and no chatter during the first pass on aluminium.

What comes with the 13523604N5 end mill and what must I source separately?

The single 2 flute necked cutter is supplied; tool holders, coolant and workpiece fixturing are not included.

Which version of the Tuffcut Al 2 flute necked end mill should I select for a 6.0 mm slot?

Choose the 6.0 mm diameter variant (MPN 13523604N5) to match the required slot width.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.