M.A. Ford
M.A. Ford 13523604N3 Tuffcut Al End Mill 6.0 mm
A 6.0 mm necked two-flute aluminium end mill for high-speed milling of non-ferrous materials
- TypeCutting Tools
- 2-flute design for efficient aluminium chip removal
- necked profile reaches deep cavities without tool interference
- 0 mm cutting diameter suits standard milling tasks
- M.A. Ford manufacturing ensures consistent edge quality
- California Prop 65 warning informs safe handling practices
6.0 mm Tuffcut Al End Mill
The M.A. Ford 13523604N3 is a two-flute necked end mill with a 6.0 mm cutting diameter designed for aluminium milling. It suits CNC operators and machinists who need a dedicated tool for non-ferrous material removal.
Not for steel or high-temperature alloys
This cutter is intended for aluminium and similar soft alloys. Machinists cutting steel, titanium or hardened materials should select a tool with a different geometry and coating. The uncoated carbide substrate and sharp flute form limit performance in abrasive or high-heat applications.
6.0 mm cutting diameter
The 6.0 mm diameter is the primary dimension that determines whether this end mill fits the programmed tool path and holder. Verify the required diameter against your CAD/CAM setup before ordering.
Highlights
- 2-flute design for efficient aluminium chip removal
- necked profile reaches deep cavities without tool interference
- 0 mm cutting diameter suits standard milling tasks
- M.A. Ford manufacturing ensures consistent edge quality
- California Prop 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank size does the 6.0 mm Tuffcut Al end mill need to fit my tool holder?
The shank matches the 6.0 mm cutting diameter, so it fits any ER, collet or Weldon holder sized for a 6 mm shank.
How do I install the necked 2 flute end mill without snapping the reduced neck?
Clamp on the shank only, keep the neck clear of the collet face, and use a torque wrench to the holder maker’s spec so the neck is not crushed.
When should I replace this aluminium end mill?
Replace it when the cutting edges show chipping, flank wear becomes visible, or surface finish on aluminium degrades noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
