M.A. Ford
M.A. Ford 13519680N Tuffcut Al 2 Flute End Mill Necked 5.0Mm statue
Two-flute necked end mill for aluminium cuts 5.0 mm channels in garden projects
- TypeCutting Tools
- Cuts aluminium efficiently with two-flute Tuffcut geometry
- 0 mm necked shank reaches deep pockets cleanly
- New M.A. Ford cutter ready for immediate use
- California Proposition 65 warning informs safe handling
- Manufacturer ships direct on orders over $75
Product Identity
This item is a 5.0 mm necked end mill with two flutes from the Tuffcut Al range by M.A. Ford. It is intended for machinists and fabricators who need a small-diameter aluminium cutter for detailed milling work.
Capacity and Headroom
The 5.0 mm cutting diameter suits light profiling, slotting and finishing passes in non-ferrous materials. The necked design provides reach for deeper features, though the two-flute geometry limits chip evacuation in heavy roughing cuts.
Included Extras
No accessories, coatings or software are bundled with the tool. The shipment arrives directly from the manufacturer, and orders of $75 or more qualify for free shipping. A California Proposition 65 warning applies because the product contains listed chemicals.
Highlights
- Cuts aluminium efficiently with two-flute Tuffcut geometry
- 0 mm necked shank reaches deep pockets cleanly
- New M.A. Ford cutter ready for immediate use
- California Proposition 65 warning informs safe handling
- Manufacturer ships direct on orders over $75
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Will the 5.0 mm necked end mill clear fixtures designed for standard-length 5 mm tools?
The necked design provides extra reach so the 5.0 mm cutter can access deeper cavities without the shank contacting the workpiece or fixture.
How can I verify the Tuffcut Al 2 flute is cutting correctly after installation?
Check for consistent chip formation, minimal vibration and a smooth aluminium finish; the two-flute geometry should evacuate chips cleanly at recommended speeds.
Does the 13519680N package include collets or tool holders, or must they be purchased separately?
Only the end mill itself is supplied; ER collets, shrink-fit holders or other 5 mm clamping devices must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
