M.A. Ford
M.A. Ford 13519680 5.0Mm 2 Flute End Mill
A 5.0 mm two-flute end mill for aluminium milling, marked with California Proposition 65 warnings
- TypeCutting Tools
- 0 mm diameter suits precision aluminium milling
- Two-flute geometry clears chips efficiently in non-ferrous metals
- TuffCut AL coating reduces built-up edge for cleaner cuts
- M.A. Ford manufacturing delivers consistent tool life
- California Proposition 65 warning included for regulatory compliance
M.A. Ford 13519680 5.0mm End Mill
This M.A. Ford 13519680 end mill is a 5.0mm diameter two-flute cutting tool from the Tuffcut Al range. It is intended for machinists and fabricators who need a fresh cutter for aluminium and similar non-ferrous materials. The item arrives new and ships directly from the manufacturer.
Sustained cutting performance
The two-flute geometry provides large chip clearance that resists clogging during extended passes in sticky alloys. Steady feed rates keep the flutes evacuating swarf efficiently so the cutter runs cooler and holds its edge longer than tools that load up quickly. Consistent coolant or air blast helps maintain this behaviour over long production runs.
Pre-order checks
Verify that your machine spindle or tool holder accepts a 5.0mm shank and that the stick-out length suits your work envelope. Confirm the material you are cutting matches the aluminium-optimised design rather than hardened steels or abrasive composites. Orders of $75 or more qualify for free shipping from the supplier. California Proposition 65 warnings apply for cancer and reproductive-harm chemicals.
Highlights
- 0 mm diameter suits precision aluminium milling
- Two-flute geometry clears chips efficiently in non-ferrous metals
- TuffCut AL coating reduces built-up edge for cleaner cuts
- M.A. Ford manufacturing delivers consistent tool life
- California Proposition 65 warning included for regulatory compliance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How much heat does the 5.0 mm 2-flute end mill generate during continuous cutting?
The carbide tool runs cool when proper feeds and speeds are used; heat stays low enough for aluminium work without coolant in most setups.
What holder or collet do I need to run the 5.0 mm shank?
A 5.0 mm ER collet, shrink-fit holder or Weldon flat shank adapter matching your spindle taper is required.
Will the 13519680 TuffCut AL work in an older manual mill with R8 taper?
Yes — use an R8-to-ER collet chuck or R8 end-mill holder that accepts a 5.0 mm shank and the tool performs normally.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
