M.A. Ford
M.A. Ford 13519603N5 End Mill 5.0mm
Cuts aluminium with a 5.0 mm two-flute necked end mill for deep pockets
- TypeCutting Tools
- Tuffcut Al coating extends tool life in aluminium
- 2-flute geometry clears chips efficiently for smooth finish
- Necked design reaches deep cavities without deflection
- 0 mm cutting diameter suits precision milling tasks
- Brand-new condition ensures full factory performance
What this end mill is
The M.A. Ford 13519603N5 is a 5.0mm two-flute necked end mill from the Tuffcut Al range. It is a new cutting tool designed for milling aluminium and similar non-ferrous materials. The necked profile provides extra reach for deeper cavities or pockets. This item ships directly from the manufacturer.
Who it suits and who it does not
Machinists and hobbyists working primarily with aluminium will find the geometry optimised for that material. The two-flute design promotes chip evacuation in soft alloys. Buyers who need more flutes for harder metals, a different diameter, or a non-necked shank should look at other tooling. The product carries a California Proposition 65 warning for chemicals linked to cancer and reproductive harm.
How it fits into a setup
Use this cutter in a milling machine or CNC router equipped with a suitable 5.0mm collet or holder. The necked section clears fixture walls or deep features without shank interference. Orders of $75 or more qualify for free shipping from the supplier. No additional accessories are included with the tool itself.
Highlights
- Tuffcut Al coating extends tool life in aluminium
- 2-flute geometry clears chips efficiently for smooth finish
- Necked design reaches deep cavities without deflection
- 0 mm cutting diameter suits precision milling tasks
- Brand-new condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What machine holder do I need for the 5.0 mm shank?
Use a collet or chuck that grips a 5.0 mm shank; the necked design also needs enough reach clearance in the spindle.
Can I run this two-flute cutter in the same aluminium job as my older high-speed-steel end mills?
Yes, but the carbide TuffCut AL geometry allows higher speeds and feeds than HSS, so adjust the program to avoid rubbing.
How do I confirm the 13519603N5 is cutting correctly after setup?
Check for a smooth finish, consistent chip formation and no chatter at the programmed feed and speed for aluminium.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
