M.A. Ford
M.A. Ford 13519603N3 5.0 mm Tuffcut Al 2 Flute End Mill Necked
A 5.0 mm diameter, two-flute necked end mill designed for aluminium cutting
- TypeCutting Tools
- Precision 5.0 mm cutting diameter for aluminium
- Two-flute geometry clears chips in non-ferrous metals
- Necked shank reaches deep cavities without interference
- M.A. Ford Tuffcut Al series built for high-speed milling
- California Proposition 65 chemical warning applies
5.0 mm aluminium end mill
This 5.0 mm Tuffcut Al end mill from M.A. Ford is a two-flute necked cutter designed for aluminium milling. It suits CNC operators and job shops that need a dedicated tool for non-ferrous profiling and slotting.
California Proposition 65 notice
The product carries a California Proposition 65 warning for chemicals known to cause cancer and chemicals known to cause birth defects or other reproductive harm. Normal workshop ventilation and standard personal protective equipment address the dust and fume exposure from aluminium cutting.
Neck relief for deep features
The necked shank provides clearance when machining deep pockets or tall walls without shank interference. Two flutes give large chip gullets for efficient evacuation in aluminium, while the 5.0 mm diameter fits standard ER collets and shrink-fit holders.
Highlights
- Precision 5.0 mm cutting diameter for aluminium
- Two-flute geometry clears chips in non-ferrous metals
- Necked shank reaches deep cavities without interference
- M.A. Ford Tuffcut Al series built for high-speed milling
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How do I install the 5.0 mm Tuffcut Al end mill and what step is often missed?
Mount the tool in a precision collet or hydraulic holder, tighten to the maker’s torque value, and verify run-out with a dial indicator before cutting.
What maintenance or replacement will the 13519603N3 cutter need later?
Inspect the two flutes for edge wear after each job; re-grind or replace the tool once the cutting edges show rounding or chipping.
What limit appears first during sustained use of this aluminium end mill?
Heat buildup in the necked section reduces rigidity, so watch for vibration or dimensional drift as the first sign to pause or reduce feed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
