M.A. Ford
M.A. Ford 13519601N3 5.0 mm End Mill Garden Statue
A 5.0 mm two-flute end mill with a necked design for aluminium machining
- TypeCutting Tools
- M.A. Ford precision cutting tool for aluminium machining
- 0 mm necked design reaches deep features cleanly
- Two-flute geometry clears chips efficiently in non-ferrous metals
- TuffCut Al coating extends tool life in abrasive alloys
- California Proposition 65 warning informs safe handling practices
M.A. Ford 5.0 mm End Mill
The M.A. Ford 13519601N3 is a TuffCut AL 2-flute necked end mill with a 5.0 mm cutting diameter. It is intended for machinists and manufacturers who need a dedicated aluminium milling tool for CNC operations.
Sustained aluminium milling
The necked geometry provides extra reach for deep pockets while the two-flute design clears chips efficiently during continuous cuts. This geometry helps maintain consistent material removal rates when profiling or slotting aluminium alloys over extended cycle times.
California Proposition 65 notice
The product carries a California Proposition 65 warning because it contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Users should follow standard workshop safety practices and consult the safety data sheet for handling guidance.
Highlights
- M.A. Ford precision cutting tool for aluminium machining
- 0 mm necked design reaches deep features cleanly
- Two-flute geometry clears chips efficiently in non-ferrous metals
- TuffCut Al coating extends tool life in abrasive alloys
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the 5.0 mm Tuffcut Al end mill produce noticeable noise or heat during extended cutting sessions?
The tool itself has no motor or electronics, so it generates no noise or heat; any sound or warmth comes from the machine spindle and workpiece during use.
What machine and holder are required to run this 5.0 mm necked end mill?
You need a milling machine or router with a collet or chuck that accepts a 5.0 mm shank and sufficient rigidity for aluminium cutting.
Will this 2-flute necked cutter work on older manual knee mills that I already own?
Yes, it fits any mill that can hold a 5.0 mm shank and provide appropriate speed and feed for aluminium, regardless of the machine age.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
