M.A. Ford
M.A. Ford 1130A Twister HPD coolant drill 11.30 mm
A 11.30 mm coolant-fed drill bit designed for high-performance drilling applications
- 30 mm coolant-fed drill clears chips fast
- 5× diameter reach handles deep holes in one pass
- Twister HPD geometry reduces cutting forces
- M.A. Ford quality built for high-performance drilling
- California Prop 65 notice included for compliance
What the drill is for
The M.A. Ford 1130A Twister HPD coolant drill is a 11.30 mm high-performance cutting tool designed for precision holemaking in metalworking applications. It suits machinists and fabricators who need accurate diameter control and efficient chip evacuation during production runs.
Installation notes
The drill fits standard toolholders that accept its shank configuration; ensure the holder is clean and the drill seats fully before tightening. Coolant must be supplied through the tool at adequate pressure to reach the cutting zone. Insufficient flow or misalignment often leads to premature wear or hole quality issues.
Check before ordering
Verify that your machine spindle and toolholder accommodate the 11.30 mm diameter and the required coolant-through capability. Confirm the workpiece material and thickness match the drill’s intended cutting parameters. California Proposition 65 warnings apply because the product contains chemicals known to cause cancer and reproductive harm.
Highlights
- 30 mm coolant-fed drill clears chips fast
- 5× diameter reach handles deep holes in one pass
- Twister HPD geometry reduces cutting forces
- M.A. Ford quality built for high-performance drilling
- California Prop 65 notice included for compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I verify the 11.30 mm Twister HPD coolant drill is cutting correctly after setup?
Check that the drill produces a consistent chip flow and maintains the 11.30 mm diameter without excessive heat or vibration during operation.
What is included with the M.A. Ford 1130A Twister HPD drill and what must I purchase separately?
The package contains the 11.30 mm Twister HPD coolant drill only; coolant supply, tool holder, and compatible machine spindle are sold separately.
Which version of the 1130A Twister HPD drill should I choose for my application?
The 1130A model is a single 11.30 mm diameter, 5X coolant-fed drill; select it when that exact size and length ratio match your hole specification.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
