LPScreen
LPScreen TL140ADXP02 14" WQXGA 2560x1600 200Hz laptop screen
A 14-inch WQXGA 2560x1600 laptop replacement screen with 200Hz refresh rate, 500 cd/m² brightness and 100% NTSC colour coverage
- Compatible ModelsTL140ADXP02
- Screen Size14"
- Screen ResolutionWQXGA 2560x1600
- Sharp 2560x1600 detail on a 14 inch panel
- Fluid 200Hz refresh for smooth motion rendering
- Bright 500 cd/m² output for clear visibility
- Wide 85 degree viewing angles keep colours consistent
- 7M colours covering 100% NTSC gamut
Screen specification
This is a 14 inch laptop replacement screen with a WQXGA resolution of 2560x1600 and a 200Hz refresh rate. It delivers 500 cd/m² brightness and a 1000:1 contrast ratio with 16.7M colours covering 100% NTSC. The panel offers wide 85 degree viewing angles in all four directions.
Compatibility requirement
The part fits devices built for the TL140ADXP02 model number. Buyers who need a different screen size, resolution or connector should look elsewhere. The supplier notes that an exact model match is required and requests emailed requirements after ordering to avoid sending a compatibility model.
Deciding specification
The 200Hz refresh rate at 2560x1600 resolution is the key figure that determines suitability for high-motion use. If your laptop chassis or graphics output does not support this rate at this resolution, the screen will not perform as intended.
Highlights
- Sharp 2560x1600 detail on a 14 inch panel
- Fluid 200Hz refresh for smooth motion rendering
- Bright 500 cd/m² output for clear visibility
- Wide 85 degree viewing angles keep colours consistent
- 7M colours covering 100% NTSC gamut
Specifications
| Model | TL140ADXP02 |
|---|---|
| Part Number | TL140ADXP02 |
| Compatible Models | TL140ADXP02 |
| Screen Size | 14" |
| Screen Resolution | WQXGA 2560x1600 |
Questions about this item
Does my laptop need a 30-pin eDP connector to accept this 14" TL140ADXP02 panel?
This screen uses the standard eDP interface required by the TL140ADXP02 chassis; verify your current panel's connector pin count and cable routing before ordering.
Can I keep my original 60 Hz display cable when swapping to this 200 Hz WQXGA screen?
The 200 Hz refresh rate demands full eDP bandwidth; reuse the existing cable only if it is rated for the higher data rate, otherwise replace it.
How do I confirm the panel is running at its native 2560x1600 resolution and 200 Hz after installation?
Open the OS display settings or GPU control panel and verify the active mode reads 2560x1600 at 200 Hz; the on-screen menu will also report 500 cd/m² brightness.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



